How to Make a VAG-COM Cable

by Deborah GrayUpdated July 17, 2023
itstillruns article image
Andreas Rentz/Getty Images News/Getty Images

To use the VAG-COM Diagnostic System by Ross-Tech, a PC to OBD-II cable is required. VCDS is used to interpret on-board Volkswagen diagnostics in more specific detail than generic OBD-II software packages do. It can also be used to interpret generic diagnostic codes from cars by other makers.

You can make a generic interface cable that connects the PC to the car's on-board diagnostics outlet. The end of the cable that connects to the car will use an OBD-II connection, while the PC end will connect via universal serial bus, or USB.

Things You'll Need:

  • 4 wire USB cable
  • Wire stripping and cutting tool
  • USB connector
  • OBD-II CAN connector
  • Soldering iron and solder

1. Cut the 4 wire USB cable to the desired overall length up to 9 feet

Cut the 4 wire USB cable to the desired overall length up to 9 feet using the wire cutting tool.

2. Remove 1 inch of the outer insulation on each end to reveal the 4 wires inside

Remove 1 inch of the outer insulation on each end to reveal the 4 wires inside. If there is a metal braided sheath protecting the inner wires, fold it back away from the inner wires.

3. Remove 1/2 inch of the insulation from the tips of the 4 inner wires

23538581

Remove 1/2 inch of the insulation from the tips of the 4 inner wires, leaving the copper wires exposed.

4. Thread the exposed inner wires on one end of the cable into the USB connector in pin-out order

Thread the exposed inner wires on one end of the cable into the USB connector in pin-out order. Solder the wires firmly into place and attach the outer jacket.

5. Thread the exposed inner wires of the opposite end of the cable into the OBD-II CAN connector

Soldering Tool

Thread the exposed inner wires of the opposite end of the cable into the OBD-II CAN connector. Follow the same pin-out order as was used for the USB connector, with the same color wires for the data, ground and vbus. Solder the wires firmly into place and attach the outer jacket.

Warning

Don't cut the interface cable too deeply into the copper wires inside the cable. This will damage the inner wires, which can cause an electrical short in the cable.

Video: How to set up VAGCOM / VCDS Lite

Comments on this video:

  • Great Video... I had the issue where my COM was set up to 7 hence the program was not finding my cable thru COM 1-4
  • still does not work for me. vcds lite wont connect when selecting control module. error message No Response from Controller!

Run test to com port on adapter, says successful at 2.7ms

More Articles

article divider
×