How to Install Trim Around Closet Doors


Remodeling a home sometimes includes adding features that were missing such as a nice walk-in closest in a bedroom. If you have recently done some remodeling such as this, don't leave it half done. Decorate around the closet door to make it uniform with the rest of the room by adding a matching wood trim. This will make it look like it was there the whole time.

Things You'll Need

  • Measuring tape
  • Pencil
  • Circular saw
  • Paint
  • Paintbrushes
  • Hammer
  • Nails
  • Wood putty
  • Sandpaper
  • Measure the edge of the door opening around the door and note the length.

  • Measure a piece of trim for each side of the door and make a mark for its length.

  • Cut the pieces of trim with a 45 degree angle starting at the mark and going up and out. The angle direction of one piece of trim should be the opposite of the other trim piece. In the end if you laid them side by side, one trim piece would have a 45 degree angled cut moving up from the mark to the left, and the other would have a 45 degree angled cut moving up from the mark to the right.

  • Measure the third piece of trim, starting several inches in from one end. Make a mark at the starting point and measure the trim for the top of the door opening. Make another mark on the other end of the measurement.

  • Cut the trim piece starting at the marks and moving out from both ends at a 45 degree angle. The end result should be a piece of trim that is shorter on one side than the other.

  • Paint the trim and allow it to dry.

  • Place the trim up against the opening and tack it in place with 1 1/2-inch nails. Put a spare nail on top of the nail heads and tap it with a hammer to countersink the nails. On the top and sides of the trim, where the corners meet, tack nails through the side so that it goes into the other trim piece. Do this on both sides of the corners to secure them.

  • Fill in over the nail heads with wood putty. Also fill in any gaps between the wood trim pieces. Let the putty dry for a few hours, then sand smooth. Paint over the top to touch up.

Tips & Warnings

  • If the trim is a little too long, you can use sandpaper to wear it down. Try sanding the back side of the cut first to see if removing some of the excess on the side will help. If not, sand along the entire cut. If part of the jab is sticking out, use a plane to smooth it or sand it down.


  • Photo Credit Jupiterimages/ Images
Promoted By Zergnet


You May Also Like

  • How to Install Double Closet Doors

    Double bi-fold doors are a marked improvement over the traditional sliding doors so common on closets. While the older style of door...

  • How to Install Mirrored Closet Doors

    Mirrored closet doors come in every standard door style, including bi-fold, bypass (sliding) and traditional hinged versions. Bi-fold and bypass are the...

Related Searches

Read Article

Make an Ikea Lack Table Look Expensive With This Cheap Hack

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!