How to Use an Aluminum Siding Trim Brake

Save

An aluminum siding trim brake will make installing aluminum trim over the wood trim on your house a lot easier. The brake helps bend sheets of aluminum, making a smooth, uniform crease to form around a corner or a trim board. With no mistakes made, there are no wasted materials. A bench brake is an industrial brake; professional installers use this type. The Bench style brake is very large and expensive. Most homeowners use a hand brake, which does the job just as nicely and is less expensive.

Things You'll Need

  • Aluminum trim
  • Tin snips
  • Aluminum siding trim brake
  • Measuring tape
  • Measure the length of the trimmed area of the house you want to cover with aluminum trim. Cut the aluminum to the length needed, using tin snips.

  • Measure the width of the trim from the point where the aluminum will start to the point where the aluminum will need to be bent. Transfer the measurements to the aluminum you cut to length, making a mark where the aluminum needs to be bent.

  • Slide the aluminum into the brake, lining the mark up to the point on the brake. Lock the brake, securing the aluminum tightly into it. Lift the lever on the bending blade to bend the aluminum trim. Use the guide on the side of the brake to bend the aluminum to the desired angle. Adjust the bend in the aluminum as needed to fit tightly against the wood trim on the house.

Tips & Warnings

  • Do not rest your fingers under the bending blade or clamps, and secure the lever after every use to prevent injury to your hands.

References

  • Photo Credit building image by jimcox40 from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

  • How to Bend Coil Siding Without a Siding Brake

    A siding brake bends aluminum or bendable vinyl siding to the angles you want using leverage from a hinged joint. A purpose-made...

  • How to Use an Aluminum Brake

    An aluminum brake is a kind of brake people use when they want to put aluminum fascia on their house or trailer....

  • How to Bend Aluminum Siding

    Many house plans call for exterior curves and arches--which to many serve to enhance the beauty of the home. Aluminum siding is...

  • How to Bend Aluminum Trim for Siding

    Aluminum trim, or capping, is an essential protective element of your home. Capping covers and protects otherwise bare lumber on corners and...

  • How to Install Aluminum Trim Coil

    Many sheet metal manufacturers produce aluminum trim coil that you can install on your house to cover base materials to provide a...

  • How to Trim Coil PVC

    Trim coil PVC comes in rolls of aluminum sheeting that are usually 50 feet long and 3 feet wide. It is used...

  • How to Use a Brake Buddy

    Making aluminum soffit and fascia components during an exterior home renovation requires the use of a portable aluminum brake. The brake forms...

  • How to Use a Metal Brake to Bend a Trim Coil

    A siding brake is used to bend aluminum or vinyl trim coil to make pieces for exterior house trim. These are often...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!