How to Install Pro Comp ES3000 Shocks

Save

ProComp is a manufacturer of a wide variety of different aftermarket products, most of them in the 4x4 performance realm. They make ES3000 shock absorbers, which are used to dampen the ride on your truck or SUV, most often in the rear suspension. If you want to install ProComp ES3000 shocks on your vehicle, you can do so with some basic tools and a little bit of time. This should take under 30 minutes to do.

Things You'll Need

  • Jack
  • Jack stands
  • Wheel chocks
  • Tire iron
  • 3/8-inch ratchet and socket set
  • ProComp ES3000 shocks
  • Put the head of the jack underneath the rear axle of the vehicle. Put wheel chocks around the front wheels. Lift up the jack and put jack stands under the rear axle. Lower and remove the jack.

  • Unbolt the upper shock mounts from the frame with the 3/8-inch ratchet and socket. Unbolt the lower shock mount located on the axle with the 3/8-inch ratchet and socket. Pull the stock shock off of the frame and axle and discard it.

  • Install the ProComp ES3000 shock onto the studs on the frame and on the axle. Bolt the upper and lower shock mount to the frame and the axle with the 3/8-inch ratchet and socket.

  • Lift the vehicle off the stands with the jack. Lower the vehicle down and pull the wheel chocks out from around the front wheels.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Install Rock Siding

    Installing rock siding on your exterior wall will reinforce and add value to your home. Rock siding comes in natural and artificial...

  • How to Use a Shock Mount

    A shock mount prevents vibrations from the boom or mount stands from reaching the microphone and causing distortions on the recording. Microphones...

Related Searches

Read Article

How to Clean Your Car Headlights

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!