How do I Tighten the Visor on a Lexus RX 300?

Save

The sun visor on your Lexus RX-300 is invaluable for keeping the sun out of your eyes while you are driving. However, if your visor becomes loose, it may not stay in position and can be more of a distraction than a help. The sun visor on your Lexus is not difficult to fix if it becomes loose. The only tool you will need is a Phillips-head screwdriver. The repair time is approximately five minutes.

Things You'll Need

  • Phillips-head screwdriver
  • Open the door on the side of your Lexus that the sun visor is loose on and sit in that seat.

  • Examine the Visor assembly. The assembly is a base with a swivel joint where your visor is attached. On the side opposite that is a plastic latch that your visor clips into when it is extended outward. The side with the swivel end is the side that most often comes loose.

  • Insert the screwdriver into the screw holding the visor assembly in place and turn it clockwise to tighten it.

Tips & Warnings

  • Check the base of the assembly where the visor's swivel arm is located. If this base is cracked in any way, it could be what is making your visor loose. If it is cracked, order a replacement base and install it by unscrewing the old one, removing it and setting the new one in place and tightening it down with your screwdriver.

References

  • "Toyota Highlander & Lexus RX 300/330: Highlander 2001 through 2006 and RX 300/330 1999 through 2006"; Joe L. Hamilton; 2007
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!