Imagine looking two cords of wood in the eye and wondering how you are going to chop it all before snow starts to fly. Hydraulic log splitters use a wedge attached to a hydraulic piston to chop each log quickly and relatively easily. Log splitters can be towed to the area where you are felling trees to chop the wood on site, which will save time and effort once you get the wood home. Repairs may be required while you are on site, so you should be prepared.
Things You'll Need
- Bench grinder
- Warm soapy water
- New oil filter
- Oil catch pan
- Hydraulic oil
Loosen the nut on the bolt that fastens the wedge to the hydraulic cylinder with a wrench to remove the wedge so it can be sharpened. While the log splitter is in the horizontal position, loosen the hydraulic hose clamp to disconnect the hose from the valve. Lift the cylinder, slide the wedge forward, and lift the wedge off the log splitter. Use a bench grinder to sharpen the wedge and then reassemble the wedge, cylinder and hydraulic hose.
Remove the breather cap from the fuel tank. Flush the cap with either kerosene or warm soapy water to remove the dirt and grime buildup. Allow the breather cap to dry thoroughly before reapplying it onto the fuel tank to avoid introducing water to the fuel system.
Remove the hydraulic oil filter with an oil filter wrench. Place an oil catch pan directly underneath the oil filter to collect any wasted oil. Replace the old filter with a new filter. The oil filter should be replaced after the first 25 hours of use and every 100 hours after that. If the log splitter is used less than 100 hours in a season, the oil filter should be replaced seasonally. Check the hydraulic oil level and top it off if needed.
- Photo Credit Fire wood image by Maksim Zinchenko from Fotolia.com
How to Troubleshoot a Huskee Log Splitter
How to Repair Log Splitters. Log Splitter Instructions. Instructions on How to Build a Log Splitter. Log Splitter Tools. Featured. 10 Tips...
Two-Stage Hydraulic Pumps for Log Splitters
Hydraulic log splitters utilize a hydraulic pump ... If you can weld and either have an old hydraulic cylinder and power pack...
How to Change the Fluid in a Log Splitter
A log splitter with a piston that pushes wood onto a blade needs hydraulic fluid to move the piston. Log splitters also...
How to Bleed the Hydralics on a Splitter
When air enters the hydraulic system, the ram of the log splitter ... How to Repair Log Splitters. ... Using a hydraulic...