A 12-volt battery in a vehicle stores and releases electricity utilizing two chemical reactions. The battery contains lead plates that are immersed in sulfuric acid. Efficient operation depends upon complete submergence of the lead plates in sulfuric acid electrolyte, the correct strength of the acid and the condition of the metal plates. Loss of acidic electrolyte, contamination and lack of regular recharging can upset the chemical balance of the battery. The repair of a faulty or weak cell within a battery involves the restoration of the chemical balance.
Things You'll Need
- Battery water
- Battery acid
- Acid-resistant gloves
- Large screwdriver
- Dry cloth
Remove all the loose dirt and oil from the top of the battery with a dry cloth, giving particular attention to the areas around the vent caps; these must be free of debris before you open them.
Undo the vent caps on all the cells, unscrewing them by hand or by using a large screwdriver. Place the vent caps in a safe place. Shine the flashlight into each cell and note the depth of the electrolyte fluid. The fluid should cover the top of the lead plates within the cell by nearly a quarter of an inch. Any cells with lower levels may be unable to hold a full charge and are weak cells within the battery. Top up the level with battery water.
Refit the vent caps and charge the battery. Leave the battery for 12 hours. If a cell is still faulty, remove the vent caps again. Don goggles and acid-resistant gloves. Insert a battery hydrometer into each cell to check the specific gravity of the electrolyte. A fully charged battery has a specific gravity of 1.265 and no cell should differ by more than 0.05. Add acid to any cell below the minimum specific gravity, following the manufacturer's instructions.
Recharge the battery and test it again. If a cell is still faulty, it probably has been damaged by sulfation. The cause, low specific gravity of the electrolyte, converts lead and sulfuric acid into hard, lead-sulfate crystals. Take the battery to a technician who can advise whether to repair the battery or buy a replacement.
Tips & Warnings
- Charge your battery every two weeks to maintain best performance and to limit sulfation.
- Always check the electrolyte levels prior to charging the battery.
- Battery acid is corrosive. Always wear personal protective equipment and know what to do if you spill acid.
- Battery electrolyte is poisonous. Keep your eyes protected and your mouth shut as you work with it.
Difference Between Citric Acid & Ascorbic Acid
Citric acid and ascorbic acid are common ingredients in a variety of products. They’re also found in some of the same foods,...
Signs of a Weak Car Battery
A weak car battery can seriously disrupt a vehicle's starting ability and, in many cases, prevent a vehicle from being started at...
How to Repair a 14.4 Volt Ryobi Battery
Ryobi is a prominent maker of cordless tools and the 14.4 volt models they offer produce a lot of power. This power...
How to Restore a Weak Car Battery
You may find that for a car battery more than two years old or more, it may not hold its charge like...
How to Fix a Car Battery That Won't Hold a Charge
When you get into your car and turn the key, you expect it to start. That is what happens for the majority...
How to Repair a Battery Cable
A bad battery cable can make you think that your vehicle has serious problems. A faulty cable can make it difficult for...
How to Repair a Car Battery Cell
A car has many technical aspects and it is inevitable that parts will malfunction. You might not know where to look when...
My Milwaukee 18V Battery Won't Start Charging
Milwaukee 18-volt battery packs may contain 15 nickel cadmium cells (NiCad) or five lithium ion (Li-ion) cells. The reason your Milwaukee 18-volt...
How to Change Electrolytes in a Lead-Acid Battery
A lead-acid battery produces electrical energy by the interaction of electrolyte solution with the battery's lead plates. The resulting interaction creates a...
How to Fix a Faulty Car Fuse
Fuses protect your car from electrical short circuits and power overloads that can damage equipment or start a fire. Often, a fuse...