How to Change Remote Control Codes

Save

Changing the codes on your universal remote control is not much different than when you set them up in the first place. It should only take a few minutes.

  • Turn on the electronic component that you want to control with your universal remote.

  • Enter your universal remote into "Program" mode. Typically, this involves pressing and holding two buttons at the same time, like a "Setup" and "Device" button, or a "Setup" and "OK" button. The specifics will be different depending on your remote.

  • Press the button that you want to assign to your component. If you want to control a DVD player, for example, press the "DVD" button on the top of your universal remote.

  • Enter in your new remote code using the number pad. This should turn off the component, indicating the code was entered successfully.

Related Searches

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!