Solar photovoltaic (PV) panels generate direct-current (DC) electricity that can be used to charge a battery. A battery charge controller is used to ensure that the battery is not over-charged. Most charge controllers will indicate electricity coming from the solar panel as well as the level of the current charging the battery. If a battery is connected directly to a solar panel, however, other ways are necessary to show electricity being supplied to the battery.
Things You'll Need
- Digital multimeter
Buy a small device to measure DC voltage. Look for a digital multimeter at a local supplier or online. It should cost less than $20. The meter will have two test probes: one red and one black.
Measure the voltage at the output of the solar panel. Turn on the multimeter and turn the dial until it measures DC voltage. Place the red probe on the positive terminal of the panel and the black probe on the negative terminal. If there is sunshine directly on the front of the solar panel, the meter should show a voltage between 10 and 17 volts. If the multimeter shows no voltage, check carefully each connection on the back of the solar panel.
Measure the voltage at the point where the wires from the solar panel are connected to the battery. Disconnect the wires from the battery and measure the difference in voltage between the two wires using the probes on the multimeter. The voltage should be just a little less than what you measured on the solar panel. If the multimeter measures no voltage, check along the wires to make sure there is no break in the connection.
With the wires from the solar panel still disconnected, measure the voltage of the battery. Write down the voltage in volts. Reconnect the wires and let the solar panel charge the battery during the day. At the end of the day, measure the voltage again. You should see that the voltage of the battery has increased, indicating that it is being charged.
Tips & Warnings
- If you don't have a multimeter, check that electricity is reaching the battery by simply disconnecting the wires from the battery and touching them briefly together to see if you get a spark (this type of short circuit does not damage the solar panel). But if you want to check that the solar panel is producing the proper voltage, you will need a multimeter.
- Photo Credit multimeter image by dinostock from Fotolia.com
How to Measure the Amperage of a Solar Panel
Amperage, or amps, is a unit measure of the amount of electrons conducted through a wire in one second. It differs from...
How to Charge a 24 Volt Battery With a 12 Volt Solar Panel
Many solar energy systems use 24 volt batteries. The batteries in these systems are charged through the use of solar panels; however,...
DIY Solar Battery Charging System
Doing serious battery charging with solar energy isn't that difficult. Actually, the most critical component --- aside from the solar panel itself...
How to Set Up & Install a 12 Volt Solar Power Station
The basic solar power system contains four major parts: solar panels, a charge controller, batteries and an inverter. Output wattage of the...
12-Volt Solar Light Systems
Solar lighting systems don't need to be complex and expensive to be effective. Simple systems that involve only 12-volt power have been...