Concrete slabs are used for many purposes in construction -- as a building foundation for a house or shed, extra parking for your home, a base for a tennis or basketball court or a patio or sidewalk. Concrete is a durable, economical substance fairly easy to work with. With a little assistance, you can pour a concrete slab that meets your needs.
Things You'll Need
- Tape measure
- Spray paint
- 1 1/2-ton excavator
- 2-foot by 4-foot boards
- Safety goggles
- Vapor barrier
- Sand or gravel
- Rebar or wire mesh
- Concrete mixer
- Screed board
- Bull float
- Plastic sheathing
Spray paint the outline of the slab onto the ground.
Excavate the area inside the spray paint. Use hand tools like picks and shovels for smaller slabs; for a large slab, you can rent a 1 1/2-ton excavator. Dig a hole that goes beneath the frost line to prevent the ground from heaving up during freeze/thaw cycles and damaging the slab. Your local zoning board can tell you the depth of your frost line.
Drive wooden stakes into the ground every three feet around the perimeter of the slab.
Nail 2-foot by 4-foot boards to the stakes. Measure and cut the boards so the ends meet in the middle of a stake and not in the gaps between the stakes.
Cover the dirt at the bottom of the hole with a vapor barrier. This is a plastic sheet that prevents moisture from seeping up from the ground.
Cover the vapor barrier with sand or gravel, following local building codes regarding which material to use and the depth of the layer.
Place wire mesh or rebar on the sand or gravel base, again following local building codes.
Mix a batch of concrete, following the directions on the packaging. For smaller slabs, mix the concrete in a wheelbarrow; for larger slabs, rent a cement mixer.
Fill the hole with concrete until the concrete goes over the top edge of the frame.
Screed the slab. This smooths out the concrete and exposes low spots in the pour. With the help of a partner, drag a 2-foot by 4-foot board across the top of the frame with a side-to-side motion. Fill in any low spots in the pour, and screed the slab again.
Finish the surface of the concrete with a bull float. This is a long-handled device with a flat surface used to finish concrete. Hold the bull float on the near edge of the concrete, tilted with the back edge of the float in the air. Push the float across the concrete. Lay the float flat on the concrete when you reach the other end, and pull it back toward you.
Cover the concrete with plastic sheathing. Remove the sheathing and add enough water to keep the concrete damp once a day, then cover the slab with the sheathing again. Continue doing this for a week, then allow the concrete to cure for four to five days.
Lift the plastic sheet off the concrete and remove the wooden frame.
Tips & Warnings
- Wear safety goggles when using the saw.
- Contact your local zoning board before laying the slab to learn your local building codes and acquire any needed permits.
- Call 811 before you dig. Your local utility companies will mark their lines in your yard with spray paint. If you damage a utility line, you can be fined and held responsible for repair costs.
- Photo Credit Jupiterimages/Photos.com/Getty Images
How to Build Wooden Concrete Forms
Concrete is a strong and versatile building material. With the advent of ready mix cement, handy homeowners can do a lot of...
How to Pour a Concrete Mono Slab
A slab is always monolithic, which means it is made from a single pour of concrete. Usually when the term monolithic is...
How to Build a Concrete Slab Form
Forms hold concrete in place as the concrete cures. Slabs intended as a base for garages and storage buildings need thicker walls...