Carpet tack strips are necessary when you're installing carpet on top of a subfloor such as wood or concrete. These carpet tack strips are thin, long pieces of wood with sharp metal protrusions on the top that resemble shark teeth. These metal teeth hold the carpet in place to prevent the stretched carpet from slipping backward and exposing the subfloor and carpet padding. Installing carpet tack strips into a hard surface such as concrete may take a little bit more time, but is unavoidable when laying down new carpet.
Things You'll Need
- Dust mask
- Eye goggles
- Tape measure
- Black marker
- Carpet tack strips
- 1/4-inch diamond drill bit
- Power drill
- Plastic masonry anchors
- Cement nails
Wear a dust mask and eye goggles to protect yourself from flying dust and debris. Sweep the concrete clean of debris, dirt and dust with a broom.
Measure 1/4-inch outward from the wall where you will begin the tack strip installation, using a tape measure. Mark the floor every 2 feet with a black marker, keeping the 1/4-inch space from the wall.
Lay the carpet tack strip on the floor, making sure the tack strips line up with the marked locations to keep the 1/4-inch space along the wall. Make sure that the bottom of the carpet tack strip is flat on the concrete.
Hold the tack strip in place and outline the entire strip with a pencil, using your free hand. Remove the carpet tack strip from its placement and set it aside so you are left with the pencil outline of the tack strip.
Mark inside the tack strip outline --- in the center --- every 5 to 6 inches, using the pencil. Attach a 1/4-inch diamond drill bit to a power drill. Place the tip of the drill bit on the first mark within the tack strip outline, and drill a 1-inch hole. Continue to drill 1-inch holes on each marked location within the outline, using the power drill.
Remove as much concrete dust from the holes as you can by gently blowing into each hole.
Insert plastic masonry anchors into the 1-inch holes. Tap the plastic anchors gently with a hammer until the tops of the anchors are level with the concrete.
Place the tack strip back over the outline with the teeth facing the wall. Hammer a nail into each anchor location, using force to drive the nails into each anchor.
Repeat this entire process around the perimeter of the space for each additional carpet tack strip you will need.
Tips & Warnings
- Always wear eye protection when drilling into concrete.
- Photo Credit Jupiterimages/Comstock/Getty Images
How to Repair Carpet Tack Strip Holes in Concrete
Carpet tack strips are wooden boards installed around the perimeter of a floor to hold carpet in place. If you decide to...
How to Install a Carpet Transition Strip on Concrete
A carpet transition strip is the metal strip used to transition from carpet to wood flooring or from carpet to tile. Usually,...
How to Install Tackless Strips for Carpeting
You're ready for your first attempt at installing carpet, but you've encountered a stumbling block: You can't figure out how to install...
How to Attach Carpet to a Concrete Floor
Carpeting a concrete floor will add warmth and comfort to any room. Concrete is a sturdy foundation for installing the carpet. Before...
How to Repair Concrete Floors After Removing Tack Strips
The tack strips used to secure carpeting to a concrete slab are equipped with small, hardened nails that penetrate and grip the...
How to Install Tack Strip on Stairs
Laying carpet over your stairs gives the stairway a colorful and cozy appearance. The first step in installing the carpet is cutting...