Exposed wood beams along a ceiling can add a beautiful charm to a room. The cost of installing real beams is prohibitive, and may even require a remodeling permit in some areas due to their load on the house's frame. Instead of using the real thing, you can create faux beams out of foam insulation sheets. These sheets are 4-by-8 feet, and just a few of them can create enough beams for the entire room.
Things You'll Need
- Insulation sheets
- Tape measure
- Foam glue
- Dog brush
- Acrylic paint
- Paint brushes
- Wood screws
Cut the insulation sheets into boards. The thickness of the individual boards should match the distance you want them to extend down from the ceiling.
Glue the boards together with foam glue. You can do this in one of two ways:
1) Glue several boards together into a solid beam. This will be much more resistant to damage, but requires more foam.
2) Glue three boards together into the base and sides of a beam, leaving the beam itself hollow. This uses less foam but is more susceptible to damage.
Allow the glue to completely dry.
Drag a wire dog brush against the foam beams to add a grain texture. You can also use a nail to carve in knots and other imperfections. For the appearance of an older beam, tear out entire chunks of foam along the corners.
The more irregular your wood grain pattern is, the more realistic it will look.
Paint the beams dark brown with acrylic paint. Allow the paint to dry. This will fill in the deeper areas when the painting is finished.
Dry brush a lighter wood color onto the beams for highlight. To do this, dip the brush into paint, then wipe most of it back off onto a newspaper. Drag the brush across the beam, perpendicular to the grain. The paint will only go onto the raised surfaces, leaving the carved-in detail dark.
Have a few helpers hold each beam in place along the ceiling as you screw them in place. Use three-inch wood screws, inserted at the top edge of the beam at a 45-degree angle, going through the foam and into the ceiling.
Use one screw every foot for solid beams, and every two feet for hollow ones.
Paint the screw heads to match the beam.
Tips & Warnings
- If the foam is not long enough to stretch from wall to wall, create two beam halves that meet in the middle.
- Photo Credit covered walkway image by Chris Lofty from Fotolia.com Wood pattern and knots image by Lucid_Exposure from Fotolia.com
How to Make Ceiling Beams Out of Styrofoam
It's a beautiful room . . . well, it's almost a beautiful room. Right now it's a good-looking but slightly bland room...
How to Make Faux Ceiling Beams
To update the look of your home, install faux ceiling beams. Real ceiling beams are part of the structural framing of a...
How to Repair Styrofoam Beams
Styrofoam can be finished to replicate nearly any surface from wood grain to brick to stone. The lightweight, easily sculpted material makes...
How to Create Ceiling Beams
Ceiling beams draw the eye upward, making your room to look larger and more distinguished. If you want the look of wooden...
How to Remove Decorative Ceiling Beams
Decorative ceiling beams are non-load-bearing beams typically created by covering a foam core with wood veneer. This faux beam, connected to the...
Remodeling Ideas for Basements With Exposed Duct Work
A basement with exposed duct work can still be attractive. The duct work can actually become part of the renovation. There are...