How to Remove Rust From a Smoker

Save

There's nothing quite like the taste of smoked meat out of a backyard smoker. Whether it's pork ribs, beef brisket or sausage, using a smoker and your favorite wood for slow cooking gets results like no other. But a smoker, like any piece of cooking equipment, needs to be maintained. The metal composition of a smoker means there is a risk of rust. If you have neglected your smoker and rust has appeared, you can still get it back into shape.

Things You'll Need

  • Screwdriver
  • Adjustable wrench
  • Wire brush
  • 120-grit sandpaper
  • Orbital sander
  • Bucket
  • Liquid soap
  • Water
  • Scouring pad or sponge
  • Spray paint
  • Disassemble the smoker by removing any parts attached by screws or bolts, which will allow you to easily reach all the areas where rust may be accumulating. Inspect the smoker completely and determine all the places where rust needs to be removed. Rust may be in hidden areas inside lids or in other areas that are not immediately obvious.

  • Brush all rusted areas with a wire brush to remove loose bits of rust and other debris. Use a circular motion to work out as much loose material as possible. You can rinse the brush with water to clean it out and continue using the brush on other areas. If there is a large amount of rust on the smoker, you should rinse regularly to keep the brush clean.

  • Attach 120-grit sandpaper to an orbital sander. Put on a protective mask to prevent breathing in rust particles. Plug the device in, if necessary, and press it against the rusty area of the smoker. Use the orbital sander to remove the rust from the smoker completely or at least take the surface down as thin as possible. Move the sander in circles and avoid keeping the sander in the same place or it will wear down the surface too much. Keep working in circles until the rust has been removed.

  • Fill a bucket with soapy hot water and use a sponge or scouring pad to wash down the entire smoker. This cleaning will wash away the remaining loose material left by the sander and remove any remaining dirt or smoke still stuck to the rest of the smoker. After washing is done, let the smoker dry completely.

  • Use heat-resistant spray paint, usually found in black, and spray each part of the smoker to give it a clean, new look. Black paint will hide the stains left by the smoke and keep it looking fresh in the backyard despite even the heaviest use.

  • Reassemble the smoker by replacing all the removed parts and inserting all removed bolts or screws back into their proper positions.

Related Searches

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Clean a Cast Iron Grill

    Cast iron heats quickly, retains heat longer than most metals and is long lasting, which makes it an ideal material for outdoor...

  • Instructions for an Emeril Cast-Iron Smoker

    Cooking with cast iron enables you to cook food slowly using low heat. This "slow and low" cooking method results in tender,...

  • The Best Smokers on the Market

    A smoker is a specialized variety of grill that cooks foods slowly --- often for multiple hours --- using low temperatures, as...

  • How to Remove Rust

    Rust is tough, but you can get rid of it on most surfaces. To prevent rust from forming you should keep metals...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!