A metal roof can add hours of enjoyment to a patio, providing shade from the sun's rays and protection from rain. You can use either galvanized steel or aluminum for a metal patio roof. Both are fairly lightweight and easy to work with. Both can be painted or bought with powder-coated finishes in various colors which will last for years with little maintenance. Both can be installed on either wood or metal framework. Both will require use of ladders and some help --- panels are light, but unwieldy and hard to handle alone.
Things You'll Need
- Tape measure
- Posthole digger (optional)
- Concrete (optional)
- Post anchors (optional)
- Framing material, wood or metal
- Screw gun
- Galvanized steel or aluminum screws
- Steel or aluminum panels
Design your metal patio roof; measure width and length of your patio and decide how you want your roof to run. You can make a flat roof (with a very slight slope to let water drain), a slanted roof which falls away from the house or a peaked roof, which works well if your patio is big enough to require center posts between the corners. Any style can be built with either galvanized steel or aluminum panels.
Install your posts and build a roof frame. Wood posts are easiest --- dig holes a depth about a third of the length of the post, sink the post and fill the hole with concrete, making sure post is vertical and plumb. For a flat roof, make posts the same height; for a slanted roof, make one side slightly longer for a slope of at least one inch per foot; for a peaked roof, make center posts longer than corners. Frame the outline with 2 by 4 board. You can also use steel or aluminum posts, with framing of square or rectangular tubing connected at the corners with angle connectors and then screwed to the posts.
Cover your roof with steel or aluminum panels. For flat or slanted roofs, start at the bottom and work up, overlapping panels about 2 inches. Attach panels with galvanized steel or aluminum screws. For peaked roofs, run panels from edge to peak and cover the top with a peak ridge cap. Overlap panels at the seams; some galvanized aluminum panels have interlocking seams, with one panel sliding into the slot of the adjacent panel to eliminate overlapping. Cut panels to fit with tin snips or a metal saw.
Tips & Warnings
- Be careful cutting galvanized steel or aluminum --- edges will be sharp and can cut fingers and hands.
How to Install Corrugated Polycarbonate Sheet Patio Covers
One affordable method of adding extra space to your home is to incorporate outdoor living areas. Adding a corrugated polycarbonate roof over...
How to Build a Patio Cover
A patio cover can be a nice addition to your home and can be useful as a functional piece of furniture. It...
How to Install Porch Roof Flashing
How to Install Porch Roof Flashing. Many people who have porches attached to their homes have problems with water leaks at the...
How to Build a Roof Over a Deck
Decks are for enjoying the outdoors, entertaining friends and family, and escaping everyday life for a few hours at a time. Unfortunately,...
How do I Install a Edge Flashing on a Patio Roof?
Your roof is one of the most important parts of your home. Whether it is your patio roof or your house's roof,...
How to Put a Roof Over a Concrete Patio
Adding a roof to a patio will make it more usable, protecting users from hot sun or from rain. You can make...
How to Apply Metal Roofing Over Plywood
Rotted, sagging areas in your roof's plywood decking should be replaced prior to installing metal panels in order to prevent costly repairs...