How to Create a Hem on Aluminum Flashing

Save

A "hem," in the vernacular of the sheet metal trade, refers to a 180-degree bend. Creating a hem on aluminum flashing solves two problems. It stiffens and strengthens the flashing, and at the same time, a hem eliminates the sharp edge of the flashing. Making a hem on flashing, or any other sheet metal, is done with a metal brake. Portable brakes designed for the siding trade can be rented at many rental yards.

Things You'll Need

  • Aluminum coil stock
  • Tin snips
  • Sheet metal brake
  • Cut the coil stock to length. If you need a piece of flashing longer than the throat of your sheet metal brake, you'll have to make it in sections.

  • Mark the depth of the hem on the coil stock. Most hems are between 3/8 inch and 3/4 inch deep, with 1/2 inch being typical.

  • Place the coil stock in the brake, with the hem protruding from the throat. Move the lever to clamp the throat shut.

  • Bend the coil stock beyond 90 degrees to begin the hemming process. Bend as far as possible --- usually about 120 degrees.

  • Remove the work piece from the brake. Place the bend made in the previous step against the brake's hinge. Pull up on the bending handle to complete the hem.

Tips & Warnings

  • Unhemmed edges can be razor sharp; wear gloves when working with aluminum coil stock.

Related Searches

References

  • Photo Credit aviation tin snips image by Christopher Dodge from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

  • How to Bend Wood to Make Furniture

    Craftsmen have used wood-bending techniques to make furniture for centuries. Bent wood is used to make the backs of chairs, banisters and...

  • How to Use an Aluminum Brake

    An aluminum brake is a kind of brake people use when they want to put aluminum fascia on their house or trailer....

  • How to Wire a Stock Harley Ignition to an SE Coil

    Harley-Davidson ignition coils provide stepped-up voltage to the spark plugs. The ignition module reads engine RPM (revolutions per minute) and crankshaft position,...

  • How to Bend Aluminum Flashing

    Aluminum flashing is a lightweight but durable sheet metal that does not rust. It is used on roofs near chimneys and sometimes...

  • How to Use a Metal Brake to Bend a Trim Coil

    A siding brake is used to bend aluminum or vinyl trim coil to make pieces for exterior house trim. These are often...

  • How to Blind Flash in BIOS

    Your computer's motherboard has a program called BIOS that runs when you first start up your computer. The software regulates the motherboard's...

  • Installation of Aluminum Flashing

    Roof flashing is an effective way of preventing moisture from entering the joint where a roof is attached to the outside of...

  • How to Stiffen Sheet Metal

    Sheet metal duct work, drain pans and other products that contain large, flat sections of metal will often generate noise or disfigure...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!