How to Make a Knight's Shield for a Kid's Party

Save

Slaying dragons, sword fights and noble deeds -- all could be part of a kid's knight-themed party. With such dangerous pursuits, it's imperative that the knight have a trusty shield. With just a little imagination and some ordinary craft supplies, any young knight can have a shield that lets the other people at the party know who he is and what he's fighting for.

Things You'll Need

  • Ruler
  • Brown kraft paper
  • Black marker
  • Scissors
  • Thick cardboard
  • Masking tape
  • Craft knife
  • Colored pencils
  • Foam sheets
  • Glue
  • Acrylic metallic-colored paint
  • Holographic stickers
  • 6 inches Velcro
  • Draw a sketch of the shape of shield your child would like. Calculate the dimensions of the shield so that it will not be too big for her to carry.

  • Make a full-size template for your shield out of brown kraft paper. Fold the brown paper in half and draw half a shield with the black marker, aligning along the center fold. Without opening the paper, cut out the shield along the black markings with scissors. Give your child the shield to hold to check out its size and shape.

  • Tape the paper template to the cardboard with masking tape. Cut out the shield using the craft knife. Use long strokes to give a clean edge, and round off any sharp edges.

  • Give your child paper and pencils for him to design a crest for the shield. Cut the shapes out of foam and glue to the shield. Alternately, cut a shape out of foam, or use a ready made shape, to represent an animal and glue it to the cardboard. Apply foam stars, suns and moons for celestial themes or geometric shapes for a more generic look. If the party has a theme, such as Knights of the Round Table, incorporate elements from this into the design.

  • Paint the shield a metallic color, perhaps bronze or silver, using an acrylic metallic-colored paint. You could use spray paint or acrylic craft paint with a paint brush. Apply the paint all over the shield.

  • Paint some small foam circles with a different color metallic paint and glue them around the edge of the shield for rivets and studs. Apply holographic stickers to add shine. Add any painted elements that your child would like.

  • Attach the handle by cutting two horizontal 1-inch slits in the shield. Position these just above and below where your child's wrist is when he's holding the shield. Run the Velcro strap through the slits from the back to the front and to the back again.

Tips & Warnings

  • Consider different shapes of shields: round, oblong, hexagonal or straight at the top and curved at the bottom.

Related Searches

References

  • Photo Credit old shield image by NataV from Fotolia.com
Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

DIY Wood Transfer Christmas Ornaments

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!