Cabinet-makers and builders often rely on medium density fiberboard, or MDF, as an inexpensive alternative to plywood for shelves, cabinets and even exterior siding. Like plywood, it comes in 4-by-8-foot sheets and has a smooth face that readily accepts paint and other finishes, but it is denser and heavier. Because it is not solid wood, MDF chips more easily than plywood, so you should cut it with a high-speed saw and a fine-tooth blade. When cutting circles, a simple trick will preserve the edges and give you the best results.
Things You'll Need
- Hole saw
- 1/2-inch drill bit
- Masking tape
Cut circles smaller than three inches with a hole saw. Fit an appropriately-sized saw into a drill and set the drill at the highest speed. Mark the center of the hole on the surface of the MDF and set the pilot bit in the hole saw on the mark.
Hold the drill steady as you depress the trigger and keep it steady as the bit bores through and the saw makes contact. Let the saw cut its way halfway through the board without forcing it. Go to the other side of the board, place the pilot bit in the hole and finish the cut from that side.
Draw the outline for a circle larger than three inches in diameter on the surface of the board with a compass and a pencil. Drill a 1/2-inch hole through the material so that one edge of the hole touches the pencil mark.
Fit a high-speed jigsaw with a metal-cutting blade, place the blade through the hole and set the base of the saw on the surface. Depress the trigger to start the saw and cut around the outline, keeping the base in contact with the MDF at all times. Keep your eye on the front of the blade to make sure it stays on the line. You may have to stop periodically and brush or blow away sawdust.
Lay a solid layer of masking tape on both sides of the board that completely covers the area of the circle as an extra precaution against chipping. If the circle is very large, lay the tape around the perimeter. Draw the outline on the tape and cut directly through it. When you are finished cutting, pull off the remaining tape.
Tips & Warnings
- You can also cut circles of any size in MDF with a bandsaw or a plunge router. Construct a jig and proceed with care when using a router. It's harder to handle than a saw and you can easily lose control.
- If you saw completely through MDF from one direction with a hole saw, the saw will chip out the surface on the other side.
- Photo Credit MDF image by Jez Hanton from Fotolia.com
How to Install an MDF Beadboard
MDF beadboard has made installing beadboard walls easier than traditional beadboard. Traditional beadboard is installed in several small strips, whereas MDF beadboard...
How to Build Furniture From MDF (Medium-Density Fiberboard)
MDF is a sheet good made from wood byproducts and adhesive, usually manufactured in 4-by-8-foot sheets. It is used extensively in the...
How to Cut a Large Circle in Plywood
Cutting a large circular hole in a sheet of plywood is a fairly simple task so long as you have the right...
What are MDF Boards?
MDF is an abbreviation for medium density fiberboard. It is a type of hardboard made from wood fibers glued under intense heat...