How do I Remove the Plastic Water Tank on a Frigidaire Refrigerator?

Save

Refrigerators with water dispensers and ice makers use a water supply system -- including water lines, valves, filters and a tank -- to supply these components. The plastic water tank in Frigidaire refrigerators equipped with water and ice dispensers is normally located behind the crisper drawers inside the refrigerator. Remove a damaged water tank to replace it with a new one, but note that this type of repair is usually made by qualified service professionals.

Things You'll Need

  • Wrench set
  • Large pan or bucket, minimum 3-qt. capacity
  • Utility knife
  • Unplug the refrigerator from the power source, and move the unit away from the wall if necessary to provide enough room to access the back.

  • Close the water line valve that supplies water to the refrigerator.

  • Disconnect the water supply line that connects the refrigerator to the household water line, using a wrench.

  • Place a 3-qt. or larger capacity pan behind the refrigerator, next to the water solenoid valve.

  • Disconnect the water tank inlet line at the water solenoid valve, using a wrench. Place the water tank inlet line into the pan to catch the water that will drain from the line when it's completely removed.

  • Reconnect the water tank inlet line to the water solenoid valve, using a wrench, when all the water is drained from the line.

  • Open the refrigerator door. Grasp one crisper drawer by its handle with both hands, and pull straight back to remove it from the support slots holding the drawer in place. Repeat with the other crisper drawer.

  • Pull straight back on the water tank to access the water tubes.

  • Cut the water tubes off within 1 inch of the tank, using a utility knife.

Related Searches

References

Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!