How to Set an Automatic Pool Filler

Set an automatic pool filler to fill your pool so you can enjoy a nice swim.

Setting an automatic pool filler is relatively simple, and a great, efficient way to fill your pool. Of course, each pool filler will be a bit different from one another, so specific instructions for setting automatic pool fillers may vary. However the basic process for setting up all automatic pool fillers is quite similar.

Things You'll Need

• Materials eeded will be provided with your automatic pool filler

Instructions

1. Read your manual and familiarize yourself with the names of all the different parts of your automatic pool filler.

2. Install the leveler bucket so that the top raises no more than one inch above the bond beam. Then install the ring and lid so that they are level with the deck. Use the provided rebar mounting flange to keep the bucket level.

3. Install the one and one half inch pipe in the appropriate spot. This will most likely be located on the side of the pool filler. Make sure that it is straight when it is installed. Then connect the three-quarter-inch fresh water supply pipe to the proper location on the side of the leveler bucket.

4. Clear all excess debris by removing the test plug and flushing the supply line for at least one minute.

5. Connect the three-quarter-inch overflow pipe in the correct port. This will be located on the side of the leveler bucket toward the top.

6. Follow specific instructions for your automatic pool filler to install the valve assembly fluid master valve.

7. Turn clockwise or counter clockwise while lightly pressing down the top of the fill valve to adjust the valve. This will adjust the float height of the fluid master valve. Continue this process until your desired water level is achieved.

References

• Pent Air Pool: Automatic Pool Filler Installation Manual