Installing car alarms are as important as installing a door locking system in your car. Homemade car alarm systems revolve around a simple concept of making a loud noise and a means of triggering it. Traditionally, alarm systems work via radio signals to trigger several other mechanisms such as alerting the police or automatic checking of locks. By following a few simple rules, you can build your own cost effective and efficient homemade car alarm system with the help of a few household items.
Things You'll Need
- Insulated wires
- Wire stripper
- Electric alarm
- Battery and clip
- Wooden alligator clip
- Cardboard strip
- A piece of plywood
- Electrical tape or glue
Use a wire stripper to remove the insulation from the wires and attach one end of the wire to the positive terminal of the battery clip and the other end to the negative terminal of the battery clip. Remove the insulation from two more wires and attach the ends of one of these to the positive terminal of the electric alarm and the other end to the negative terminal of the electric alarm.
Use glue or tape to secure the electric alarm and battery clip to the plywood. Ensure that the electric alarm and the battery clip do not touch together. These can be close but not touching.
The loose end of the wire connected to the positive terminal of the battery clip will be tied around the upper jaw of the wooden alligator clip. The loose end of the wire connected to the positive terminal of the electric alarm will be tied around the lower jaw of the wooden alligator clip. When the clip is bunged (or plugged), the bare metal parts of both the wires should come into contact.
Cut out a piece of cardboard and place between the jaws of the alligator clip to create an obstacle between the two wires. Cut out the cardboard so a considerable length should go beyond the length of the alligator clip.
At the far end of cardboard, create a hole with the help of a pin and put a small length of sturdy string through it. The hole should be made so if the cardboard is pulled out of the jaws of the alligator clip, it won't tear apart. Once the cardboard is pulled out and the two jaws connect, the alarm will be triggered.
Stick the alligator clip to the plywood using glue or electrical tape, then glue or tape this piece of plywood under the seat of your car or a convenient place where the mechanism will not be visible easily.
The piece of sturdy string going through the cardboard must be connected to the locking mechanism of the car. Tie the string around the locking mechanism so it triggers with a keyless entry. Insert batteries into the battery clip and test your alarm to make sure it works.
- Photo Credit locked car image by Yasen Pramatarov from Fotolia.com
How to Install a Car Alarm in a Car
Have you recently purchased a security system for your car? Since there are so many different types of alarms it can be...
How to Build a Fake Car Alarm Light
A car alarm can discourage a thief from stealing a car--but so can a fake car alarm, if the thief thinks it...
How to Make a Homemade Alarm System
Home alarm systems are based around a very simple system: a loud noise and a means of triggering it. Fancy home alarm...
How to Stop a Car Alarm
Most cars with car alarms come with a key fob that is used to lock and unlock the car doors from a...
How to Make Homemade Model Cars
If you want to make your own homemade model car, one option is to make one with wood. Using wood will be...
How to Make a Car Alarm More Sensitive
Car alarms are equipped with sensors located throughout the vehicle that act as detection devices. The most common sensor is linked to...
Homemade Car Detergent
From gasoline to insurance to tires, car ownership can be very expensive. There is also the added expense of making your car...