How to Install a Jacuzzi Filter

Jacuzzi manufactures many types of water appliances such as hot tubs, bath tubs, showers and sinks. Jacuzzi hot tubs are often found outdoors, and can accommodate four to 10 adults, depending on the model. Jacuzzi hot tubs utilize a filtration system that helps keep the water clean of debris. The filter should be cleaned approximately once per month to ensure maximum efficiency of the hot tub.

Instructions

1. Disconnect power to the Jacuzzi hot tub by turning off the breaker in your fuse box.

2. Locate the filter strainer lid assembly, which is a flat, square panel on the inside wall of the Jacuzzi, often near the control panel.

3. Pull the filter strainer lid assembly off of the wall by pulling it straight back.

4. Remove the old filter, if one is installed, by turning it counterclockwise.

5. Insert the filter into the filter slot at the bottom of the well behind the strainer lid assembly.

6. Screw the filter into the filter slot by turning it clockwise until tight.

7. Replace the filter strainer lid assembly, then restore power to the hot tub to complete the installation.

Tips & Warnings

• Never operate the hot tub without a filter.

References

• Jacuzzi: 2010 J-200 Series Manual