How to Wire Speakers in a 1998 Chevy Blazer
The 1998 Chevy Blazer is equipped with factory-installed speakers. When replacing these speakers with aftermarket models, there are some instances in which the aftermarket speaker terminals do not match those of the factory-installed speaker. In these cases, the speakers must be wired to the existing car speaker. This can be done with some basic wiring tools.
Other People Are Reading
Instructions
-
-
1
Unplug the speaker wire connector from the back of the old speaker.
-
2
Cut off the connector from the speaker wires with a set of wire cutters. Cut as close as possible to the connector, preserving the maximum amount of wire.
-
-
3
Remove 3/8 inch of insulation from the ends of the wires, using a wire stripper.
-
4
Place a slide connector onto each of the bare wire ends. Crimp the connectors onto the wires with a crimping tool.
-
5
Push the slide connectors onto the terminals of your new speaker to wire the speaker into the audio system.
-
1
