How to Calculate Limit of Detection (LOD)

Instrument readouts show peak results above or below a baseline reading.
••• Heartbeat image by JASON WINTER from Fotolia.com

Analytical instruments are used to detect, quantify and qualify almost everything imaginable. Detection of energy or matter requires a baseline reading (no analyte) and a signal generated by the analyte of interest. Baselines are not perfectly flat-they have mild deviations known as "noise." Limits of detection generally require the analyte signal to be from three to 10 times greater than the "noise" fluctuations.

    Look closely enough at a baseline and you will see noise.
    ••• display of waveforms image by Albert Lozano from Fotolia.com

    Establish a baseline. Run the analytical instrument in the absence of the analyte to determine the baseline value of the detector. Stable baselines should not drift up or down.

    Find an average value for the baseline.
    ••• business line graph image by Nicemonkey from Fotolia.com

    Examine the baseline and determine an average value. Use the instrument's integration capability or draw a line through your best-guess at what the average value is between up and down noise. Note the value of the average on the readout scale (y-axis value).

    Find the average height of 10 noise peaks.
    ••• Calculator image by Alhazm Salemi from Fotolia.com

    Determine the noise. Measure 10 peaks above the average value for your baseline. Add the values together and divide by 10. This is your average noise value. Note: Some instruments have "system" peaks that are predictable and much higher (or lower) than baseline--if you can predict the system peak, it doesn't count in determining noise.

    Use the baseline to measure peak height.
    ••• Heart beat chart image by Sophia Winters from Fotolia.com

    Add a standard of known value. Introduce an energy of known value (a sound, light, or electrical input for energy analysis instruments) or a chemical quantity of known value. Start with a high concentration of the standard so you get a good peak in the readout. Note the value (concentration or strength) of the standard and the value of the peak height. Measure from the top of the peak to the baseline.

    Determine absolute limit of detection. Reduce the concentration or intensity of the standard. Input a smaller signal or concentration until the analyte peak is about three times the height of your average noise peak. This intensity or concentration is the absolute limit of detection.

    Determine the quantification limit of detection. Increase your input intensity or concentration to the point the peak height is 10 times the average noise peak. This is the lowest concentration for which you can reasonably state the concentration or intensity of the analyte.

    Things You'll Need

    • Analytical instrument
    • Experimental result
    • Peak height measurement

    Tips

    • Any change in chemical or equipment parameters requires recalculation of baseline noise and limits of detection. Some machines require substantial warm-up time before they give an even baseline. Wait until conditions are stable before you figure your limits of detection.

    Warnings

    • Researchers are often tempted to use the absolute limit of detection for the limit of quantification. It gives them more data and makes it seem as if they have a more sensitive protocol-but isn't good science. Be conservative and honest for more robust data and a more solid reputation.

Related Articles

How to Calibrate an Infrared Spectrophotometer
How to Measure Current With an Oscilloscope
How to Calculate Alias Frequency
How to Convert PPM to NTU
How to Calculate dB Loss
How to Calculate Signal to Noise Ratio
The Advantages of Potentiometric Titration
Activation Energy of the Iodine Clock Reaction
What Is the Decibel Level of a Jet Plane?
How to Calculate Thermocouple Sensitivity
How to Interpret XRF Data
Types of Spectrometers
How to Convert Hertz to Nanometers
How to Measure Noise Pollution
Statistical Analysis Tools
Duty Cycle Formula: How to Calculate the Duty Cycle...
How to Calculate Absorbance
How to Design an RC Snubber
What Are the Functions of TSH?

Dont Go!

We Have More Great Sciencing Articles!