Having a sling on your firearm brings advantages, including being able to carry it over your shoulder, freeing up your hands for other tasks. Many shotguns, epically double-barrel models, do not come equipped with factory installed swivel-studs for attaching a sling. Adding sling swivel-studs on a over-under shotgun is not a complicated process, but there are a few details that you must pay attention to. Most critical is that you do not try to install the rear stud too close to the butt end of the gun, or the wood can split and ruin the stock.
Things You'll Need
- Masking tape
- Tape measure
- Felt-tip pen
- Drill guide
- 1/8-inch drill bits
- Fixed sling-swivel stud
- Small Philips-head screwdriver
- Clamp-on sling-swivel stud
- Hex head screwdriver
- Thread sealer
Open the vise wide enough to accommodate the shotgun stock. Fold the towel in half, the long way, and lay it across the jaws. Insert the shotgun stock, upside-down, halfway into the vise with the towel padding the gun. Close the vise just enough to hold the stock in place.
Cover the ridge along the bottom (that is now facing upward) of the butt of the stock with masking tape. Measure in a minimum of 2 inches from the butt end of the stock with the tape measure and mark with the pen. Be sure to measure from the wood, not the recoil pad.
Attach the drilling guide to the stock, aligning the guide hole in drilling guide in the center of the stock ridge and with the pen mark on the masking tape.
Attach the drill bit to the drill. Insert the drill into the drill guide and drill the hole in the stock. Remove the drill guide and the masking tape.
Twist the swivel-stud threads into the hole as far as possible with your fingers. Insert the Phillips-head screwdriver into the hole in the stud. Using the screwdriver for leverage, finish twisting the stud, a half-turn at a time, until the head is seated against the wood.
Open the clamp-on swivel-stud with the hex head screwdriver and place it around the barrel, approximately 1 inch in front the forearm (front) of the stock.
Apply a drop of thread sealer to the clamp-on swivel-stud’s screw and tighten in place.
Tips & Warnings
- Use the metric (centimeter) side of the tape measure to be sure the rear swivel-stud goes in straight by measuring the distance between the stud’s head and the wood, on all sides, every few turns.
- “The NRA Gunsmithing Guide”; Ken Raynor and Brad Fenton; 1983
- Photo Credit Jupiterimages/liquidlibrary/Getty Images
How to Put a Sling on a Shotgun
Shotgun slings are used by many people as a means to carry a shotgun while in the field or to aid in...
How to Tighten a Shot Gun Barrel
Shotguns are made up of many parts, including springs, pins, rings, screws and many other carefully machined parts. After thousands of firings...
How to Attach a Sling to Swivels
A sling is one of the most important accessories for your shotgun or rifle. It gives you a convenient method for carrying...
How to Put on a Gun Sling on a Remington 870 Shotgun
The pump-action design of the Remington 870 is rugged and reliable, making it suitable for hunting, self defense and tactical applications. The...