How To Repair Tears in Pool Table Felt

Save

The felt on your pool table may become ripped if people use it inappropriately or if the end of the pool cue hits it too many times. A completely new felt can be difficult to install and may cost a lot of money. Performing a pool table repair requires some skill due to the slate underneath the felt. If the slate is damaged during the repair, the table may have a small dip, affecting the ball roll during play.

Things You'll Need

  • Pool table repair kit
  • Knife
  • Hammer
  • Thread the curved needle with the felt thread.

  • Insert the curved needle into the felt about 1 inch away from the repair. Pull the needle under the felt and out towards the beginning of the tear, leaving 1 inch of thread remaining at the point where the needle was inserted.

  • Bring the tip of the needle through the felt about 1/8 inch away from the edge of the tear on the right-hand side. Pull the thread taut and insert the needle again into the other edge of the tear about 1/8 inch away to start the stitch. Continue working your way up the tear in the same manner.

  • Bring the needle under the felt at the end of the tear and bring the remaining thread up through the felt. Cut the thread away with your knife.

  • Press the head of your hammer onto the seam to flatten the threads. Do not hit the threads since this may damage the slate underneath the felt. Test the flatness of the thread by rolling a ball over it. Flatten it more if necessary.

References

  • Photo Credit Inti St. Clair/Photodisc/Getty Images
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!