How to Install a Navman 3450
The Navman 3450 is a global positioning satellite, or GPS, system that is used with PocketPCs such as the Hewlett Packard iPAQ H3700, H3800 and H3900 handheld devices. The Navman 3450 GPS system involves two parts: a GPS receiver and the GPS software that is installed on the iPAQ. The Navman uses power from the iPAQ's batteries, so either have a portable charger on hand or make sure the iPAQ is fully charged before using the Navman.
Other People Are Reading
Instructions
-
-
1
Place the iPAQ into the Activesync cradle that came with the iPAQ. Connect the USB cable from the cradle to a USB port on a separate computer.
-
2
Insert the SmartST CD included with the Navman 3450 into the disk drive of the computer. An installation wizard will start up.
-
-
3
Click on "Install SmartST Professional."
-
4
Click on "Next." Enter the product key and click on "Activate Software." Click on "Next." Then click on "Finish." The product key is located on the packaging for the SmartST CD.
-
5
Remove the iPAQ from the Activesync cradle and attach it to the Navman 3450 receiver. Push down until it clicks into place.
-
6
Tap "Start," then "SmartST Professional" on the iPAQ.
-
7
Click "Destination" and enter a destination for which you want directions. When the GPS displays the navigation instructions, you have verified the Navman is working.
-
1
Tips & Warnings
You generally can get a signal on the Navman only while outdoors. It may take a few minutes to acquire the satellite signal.
