Drainage pipes-known as sewer lines-are usually made of PVC or ABS black plastic. However, older sewer lines can be made of lead, cast iron or clay. Damage to an underground sewer line can be caused by the ground shifting or even a slight earthquake. With no room to leverage the pipe to fit new rigid plastic couplings, a new piece of pipe is installed using flexible rubber couplings. Once the hole has been dug, the job is fairly simple to carry out.
Things You'll Need
- Felt-tip pen
- Hacksaw, cut-off saw or reciprocating saw with a metal-cutting blade
- Utility knife
- Tape measure
- PVC sewer pipe
- 2 flexible rubber couplings
- Eye goggles
Dig a hole down to the area of broken sewer pipe. Make sure that 6 inches of earth is removed below the broken pipe area.
Cut through the pipe 2 inches on each side of the broken area. Mark the pipe first with a felt-tip pen, and use a hacksaw or power saw to make the cut. Be sure that the cut is straight and remove any burrs with a utility knife. For lead pipes, also use a hacksaw. For clay pipes, use a cut-off saw; and for cast iron pipes, use a reciprocating saw with a metal-cutting blade.
Measure the distance between the two pipe cuts and cut a new piece of PVC pipe to that length. Make sure the new pipe is the same diameter as the existing sewer pipe.
Push flexible rubber couplings fully onto each of the existing cut pipe ends. Apply soapy water around each pipe end if the coupling is hard to slip on.
Place the new piece of PVC pipe between the two existing pipe cuts and slip both flexible couplings onto the new pipe section, so that half of each coupling is on the old pipe and half on the new pipe. Tighten the metal straps surrounding each end of one coupling with a screwdriver. Now tighten the straps on the other coupling.
Pour fine gravel around the sewer pipe for support and to fill in the hole.
- "Home Improvement 1-2-3"; Benjamin W. Allen, Christopher Cavanaugh; 1995
- Photo Credit hack-saw image by Aleksandr Ugorenkov from Fotolia.com
ABS Pipe vs. PVC
Acrylonitrile butadiene styrene and polyvinyl chloride piping both are made from plastic, but they aren't made the same. ABS is not quite...
How Deep Should an Underground Drainage Pipe Be?
Underground drainage pipes are a simple way to drain areas that are prone to remaining wet long after any significant rainfall. Drainage...
How to Repair a Broken Underground Water Line
How to Repair a Broken Underground Water Line. If you suspect that your water pipes are leaking because your water bill has...
How to Unclog Underground Rain Gutter Drain Piping
A rain gutter drain pipe is usually installed to carry water away from your house. Many of these pipes are placed underground...
How to Repair Sewer Pipes
Damaged and broken sewer pipes cause homeowners much anxiety and expense. While the fear of exacerbating the problem often keeps people from...
How to Repair an Underground Water Leak
Underground pipes supply water from the city water meter to the house, or, in some cases, to an irrigation system. They also...
How to Repair Vitrified Clay Sewer Pipes
Vitrified clay sewer pipes have proven to be long-lasting. VCP for short, the vitrified pipe has a high resistance to sulfuric acid...
How to Repair a Broken Drain Pipe
A broken drain pipe is a recipe for water damage beneath your sink if it is not promptly and properly remedied. A...
PVC Underground Drainage Pipe Installation
PVC is a hard plastic used in the manufacture of household drainage (sewer) and vent lines. The pipe comes in a diameter...