Enjoying a family barbecue on a backyard deck embodies the joy of summer. Exterior decks add family activity space and lend themselves to quiet reflection as well as warm weather entertaining. But maintaining an exterior deck can be a chore -- especially when deck boards become warped or damaged. Fortunately for deck owners, replacing deck boards is a process that any homeowner can manage. The key to successfully replacing damaged deck boards is having a plan and then sticking to it.
Things You'll Need
- Jig saw or saber saw
- Circular saw
- Crowbar or pry bar
- Tape measure
- Screwdriver or screwdriver drill bit
- Sealant, stain or paint
- Paint brush
- Scrap wood piece
- Screws or nails to match deck
Cut the damaged plank with a jig saw or saber saw so that the damaged portion can be removed from the deck. Use a single cut across the damaged board so that the board is split into only two pieces. Take care not to damage the adjacent deck boards.
Pry the damaged portion of deck board loose from the underlying joists by placing a piece of scrap wood on the deck and using a crowbar to pry the damaged board up, starting from one end and gradually moving to the other. Remove the nails or screws fastening the damaged board to the joists as you go.
Mark the placement of the nearest joist under the damaged portion of board decking on the board, then lift the board up and use the square to mark the center-line of the joist across the face of the board.
Move to the other end of the damaged board and mark the placement of the nearest joist past the damaged area. Again, lift the board up and use your square to mark the center-line of the joist across the face of the damaged board.
Cut the damaged plank along each of the center joist lines to remove the damaged portion of the board; leave the undamaged portion(s) of the board ready for re-attachment.
Measure the length of the opening for the replacement board and mark the replacement board accordingly. Then cut the replacement board to match the opening.
Place the replacement board into the opening on the deck and secure it to each underlying joist using nails or screws that match what was originally used to build the deck. You may want to drill pilot holes for each nail or screw prior to attachment. Be sure to counter-sink screws to make them flush with the surface of the deck.
Sand the surface of the installed replacement board, especially at the ends, to ensure a snug, smooth fit. Then treat the board with sealant, stain or paint that matches the original decking.
- Photo Credit Deck de madeira image by CarlosNeto from Fotolia.com
How to Replace Damaged Deck Boards
If you have only a few cracked or rotted sections on your deck, replacing a board or a section of one could...
How to Remove Old Deck Boards
One way to keep your deck looking good is to replace old deck boards that have splits or rotten spots. Replacing deck...
How do I Replace Deck Boards With Trex Decking?
Replacing your existing deck's boards with Trex offers more than a facelift. Trex decking is an attractive alternative building material invulnerable to...
Alternatives to Replacing Deck Boards
A wooden deck can present a lot of work for the owner. Over time, wood becomes damaged or unsightly if not cared...