Jacuzzi Espree Instructions
The Jacuzzi Espree is a jetted bath tub, also sometimes called a spa, for home or recreational use. The tub should only be installed by a professional and operated by adults familiar with large home appliances. Children should never be allowed near or in the Espree unless supervised and pregnant women are advised not to use the Espree unless approved by a physician due to hot water temperatures. Other instructions for the Jacuzzi Espree are relatively simple to follow. Does this Spark an idea?
Instructions
-
-
1
Close the drain and open the water taps with hot or lukewarm water. Allow the tub to fill with water until the jets are at least 2 inches under water.
-
2
Push the "On/Off" whirlpool switch, located on the side of the tub, to turn on the whirlpool jets.
-
-
3
Turn the timer knob to the desired amount of time. If less than 10 minutes are desired, turn the knob past the number 10 and then back to the desired minute amount.
-
4
Turn the jet nozzles to the desired angle during the bath. To create a whirlpool effect, turn the jets in the same direction.
-
5
Turn the control knobs, located at the front of the tub, in a counterclockwise motion to increase the air supply and create larger bubbles. Turn the knobs clockwise to reduce the amount of air in the water and create smaller bubbles.
-
6
Press the "On/Off" button to turn off the jets. Open the drain to let the water drain out of the tub.
-
7
Clean the tub when empty with a non-abrasive liquid detergent. Rinse well with water.
-
1
