Knowing how to make your own waterproof low-voltage connectors will come in handy when working on wiring exposed to the elements. They come in especially handy when working on low-voltage landscape lighting and automotive wiring. Making waterproof connections is crucial when working with low-voltage circuits because any current leakage to ground can cause serious problems. The connectors are easy to make using commonly available materials and tools that can be purchased at home centers and hardware stores.
Things You'll Need
- Wire cutters
- Wire strippers
- Assorted sizes of heat shrink tubing
- Crimp-on terminal assortment
- Crimping tool
- Industrial hot air gun
Select a piece of heat shrink tubing slightly larger in diameter than the crimp-on connector that you are going to use to make the waterproof connector. Cut the heat shrink tubing one inch longer than the crimp-on connector. You will want the heat shrink tubing to extend at least ½ inch beyond the ends of the crimp-on connector.
Slip the section of heat shrink tubing over one of the wires to be spliced together. You make your own waterproof connector at the same time you make the waterproof connection; it is an all-in-one process. This is just one method for making do-it-yourself waterproof connectors, but it is the easiest method for the inexperienced do-it-yourself person to master.
Grasp one of the wires firmly in your left hand and strip 3/8 inches of insulation from its end. Grasp the remaining wire firmly in your left hand and strip 3/8 inches of insulation from its end.
Connect the two, stripped ends together using a crimp-on butt connector. Crimp-on connectors are color coded by wire size. The three most common sizes are designated by Red, Blue and Yellow insulated sleeves. The Red connectors are designed for use with AWG 22 through AWG 18 stranded wire. The Blue connectors are designed for use with AWG 16 through AWG 14 stranded wire. The yellow connectors are designed for use with AWG 12 through AWG 10 stranded wire. Match the color-coded jaws on the crimping tool with the color of the connector.
Center the shrink tubing over the crimped connector. Plug in the hot air gun and apply the heat evenly along the full length of the heat shrink tubing. Use caution when using an industrial hot air gun—it is not a hair dryer. A hot air gun gets hot enough to peel skin from your fingers.
- Photo Credit hot air gun image by patrimonio designs from Fotolia.com
Installing Waterproof Outdoor Lighting
Outdoor lighting can provide security, safety, and style to your dwelling. You want to be sure that any lighting you install is...
How to Repair Low Voltage Landscape Lighting
If some of your outdoor low voltage landscape lighting is not working, the most likely cause is a bad connection. Landscape lighting...
How to Add Lines on a Malibu Outdoor Lighting Transformer
Your garden or yard landscaping isn't laid out in a straight line; neither should your Malibu low-voltage landscape lighting design be limited...
How to Wire Low-Voltage Indoor Lighting
Low-voltage lighting has become increasingly popular in homes, hotels, restaurants and retail stores. A typical low-voltage system reduces your 120-volt residential electricity...
How to Splice Low Voltage Wires
You can splice low voltage wires with solder and electrical tape or with various connectors or splicing kits. Choose your connecting method...
How to Splice Outdoor Electrical Wire
You can splice an outdoor cable in several ways. The easiest way to splice any cable is to cut it, then connect...
How to Waterproof Splice an Electrical Wire
Waterproofing a spliced electrical wire can be done in minutes using waterproof caulk and electrical tape. Even though the spliced wire is...