How to Build a Flatbed Truck Out of Wood

by Jesse James Dean
itstillruns article image
Photo courtesy of rookery2.viary.com

Flatbed trucks are gaining popularity, especially within the farming community. A flatbed made from wood is convenient, inexpensive, and able to outlast a stock steel truck bed. The most appealing aspect of a wood flatbed is that you can design and build it yourself rather than purchasing an expensive, premade steel flatbed. Building your own wood flatbed will give your truck that personal touch and save you money.

Step 1

Measure and cut the foundation. Lay three 4-by-4 inch pieces of lumber across the width of the truck frame, then mark the desired length using your pencil and square. Once this is done, cut the lumber to length.

Step 2

Cut the floorboards to length. Measure the 2-by-6 inch lumber against the length of the truck frame, then mark and cut it. Measure and mark each piece individually to ensure it is the correct length.

Step 3

Mock up the flatbed. Begin by laying the 4-by-4 inch lumber across the frame of the truck, one each at the front and back and one across the middle, parallel to one another. Place the 2-by-6 inch lumber on top of and perpendicular to this foundation, laying each piece flat, side by side, until the entire area is covered. Once all the pieces are in place, check your work. If you need to adjust the length or width of any of the boards, mark and cut them.

Step 4

Install the foundation. Once your final adjustments have been made, remove the 2-by-6 inch floorboards. Make sure the three pieces of 4-by-4 inch lumber are positioned as described in Step 3. Drill through both ends of each piece of 4-by-4 inch lumber into and through the frame of the truck. Place a lag bolt in each hole from the top, thread a nut onto the bolt from the bottom, and tighten it with a wrench.

Step 5

Install the floor. Lay all of your 2-by-6 inch floorboards in place. Where each floorboard intersects a foundation board, drill a hole through the center of the floorboard into and through the underlying foundation. You will make three drill holes for each floorboard. Place a lag bolt in each hole from the top, thread a nut onto each bolt from the bottom, and tighten with a wrench.

More Articles

article divider
×