Weathervanes turn and spin when the wind blows, showing which direction the breeze is coming from. They can also help homeowners predict when storms are coming. If the weathervane spins nonstop, odds are a rough wind is signaling a thunderstorm. Weathervanes also add a touch of whimsical decoration to your home. Copper vanes hold up easily against the elements and develop a vintage-looking patina over time. Copper is also one of the easiest metals to work with, so you can easily make a copper weathervane at home.
Things You'll Need
- Tape measure
- ½-inch-thick copper pipe
- 16mm copper sheet
- Grease pencil
- Tin snips
- Coarse sandpaper
- Outdoor metal adhesive
- Hand drill
- ¼-inch-thick drill bit
- Wooden garden stake
- Large steel nail
- Steel washer
Measure about 2 feet in from one end of your copper pipe, using a tape measure. Make a grease pencil mark around the pipe and brace the pipe's body against a sturdy table. The marked spot should hang over the table a little. Draw a hacksaw firmly and slowly over the grease pencil mark until you saw through. Keep the 2-foot piece of pipe.
Measure in 1 foot from both ends of your copper pipe to find the center. Make a grease pencil mark at the center. Brace the pipe against a table. Drill straight through the pipe at the center mark with a ¼-inch drill bit, drilling completely through both sides.
Spread out your copper sheet on a flat surface. Draw two triangles with 3-inch sides near the edge of your sheet. Cut them out, using tin snips as you would scissors. Cut two, 1-inch-long slits about ½ inch apart in the base of one triangle. Do the same to your second triangle, positioning the slits on either side of the top point.
Sand both ends of your copper pipe with coarse sandpaper. Apply a little metal cement to either end. Slip the slits of a triangle onto either end of the pipe so it looks like a long copper arrow. Let the cement dry overnight.
Drive a wooden stake into the ground where you want your weathervane, using a hammer. Place a steel washer (a round, metal doughnut used as a buffer between surfaces) against the top end of the stake.
Slip a nail through the center hole in your copper arrow and place the tip of the nail in the center of the washer. Pound the nail until it's halfway buried in the wooden stake. Your weathervane should be able to spin freely.
- Photo Credit Armada Weather Vane image by Stonestill from Fotolia.com
How to Make a Wooden Weathervane
The use of weathervanes, or wind vanes, goes back to early Mesopotamia. Writings unearthed in that area dated from 3,500 years ago...
- How to Make a Simple Weather Vane
How to Quickly Patina Copper Weathervanes
Creating a patina finish on copper only requires a few household ingredients. White vinegar, ammonia and salt are the basic ingredients required...
- How Much Money Do Weathermen Make?