How to Build a Round Baby Crib


One way to keep an eye on the baby in a crib is to build a round one. This makes it possible to see the baby from any angle of the room. Round cribs must meet safety standards. This means the space between the spindles cannot exceed 2 3/8 inches and the spindles must be 26 inches above the mattress. The good thing about building a round crib for your child is the railing comes ready-made. All you have to do is drill the holes for the spindles.

Things You'll Need

  • 48-by-48-by-3/4-inch medium density fiberboard
  • 72-inch straightedge
  • 1/4-inch lattice, 30-inches long
  • Drill
  • 1/16-inch drill bit
  • Band saw (optional)
  • Jigsaw
  • 100-grit sandpaper
  • Eight swivel casters w/screws
  • Circular rail, 48 inches diameter
  • Drill bit for spindles
  • Wood glue
  • 70 spindles
  • 2-penny finish nails
  • Hammer
  • Damp cloth
  • Set the 48-by-48-by-3/4-inch medium density fiberboard on a work table along with the piece of 1/4-inch lattice. Put the 72-inch straightedge on corners that are catty-corner from each other on the fiberboard. Draw a line from corner to corner. Repeat this with other two corners to mark the center of the material.

  • Drill a hole through the lattice 1 inch from one end with the 1/16-inch drill bit. Measure from that hole, mark the lattice at 24 inches, and drill another hole in the lattice. Place the first hole on the center point of the fiberboard. Insert a box nail into the hole and hammer it in just enough to hold it firmly.

  • Insert a pencil in the other hole and draw a circle around fiberboard. Cut the circle out with a band saw or jigsaw. Sand the cut edges with a piece of 100-grit sandpaper. Install the casters around the circumference of the circular bottom of the crib according to the manufacturer’s instructions.

  • Place the piece(s) of the circular rail on the cutout. Mark the center of the railing between the outside and inside edges. Make a mark every 3 inches to indicate where the spindles will go. Drill holes on every mark 3/8-inch deep with a drill bit that matches the dowel at the end of the spindle.

  • Put a drop of glue on the end of one of the spindles and insert into a hole. Drive a finish nail through the railing into the spindle to hold it in place. Repeat this process with the remaining spindles.

  • Position the spindle assembly on the medium density fiberboard bottom and trace its pattern onto the bottom. Drill pilot holes through the railing with a 3/16-inch drill bit every 18 inches. Remove the spindle assembly, apply glue to the circumference of the bottom and secure the assembly to the bottom with the wood screws. Clean up the excess glue with a damp cloth.

Related Searches


  • Photo Credit the portrait of small boy lying in bed image by Valentin Mosichev from
Promoted By Zergnet



You May Also Like

  • How to Make a Baby Bed Bench

    Your last baby has finally graduated to their toddler bed and now you have a crib collecting dust in the corner. You...

  • How to Build Corn Cribs

    Farmers use corn cribs to store harvested corn that is still on the cob. The "crib" nomenclature comes from the open sides...

  • How to Assemble a Round Baby Crib

    Every round crib is designed differently. To know exactly how to assemble the round crib for your baby, you need the instructions...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!