×
Back Button

How to Remove Rust From a Cast-Iron Grinder

Darla Ferrara

Cast iron is malleable metal and part of a group known as ferrous alloys. Without proper maintenance, oxygen works on the properties of the cast iron to form rust. Left unchecked, rust will degrade the metal until it breaks apart. From the outside, a grinder appears to be one solid unit.

Grinders work to mince food into smaller pieces.

Once disassembled, you find many internal components, such as a grinding disc and turning screw. These pieces are responsible for mincing food. The best way to avoid rust on your cast-iron grinder is through proper cleaning. Once the rust forms, a little elbow grease will strip it off.

Warning

Use caution when cleaning sharp pieces, such as the metal disc. The edges will be raised and can cut skin.

  1. Take the grinder apart. The method will depend on the style grinder. Look for butterfly nuts or screws that will free the plate and release the components.

  2. Soak all parts in a sink full of hot, soapy water. Use a mild detergent, such as dish soap. Leave the parts in the sink for 30 minutes. This will remove some of the surface rust.

  3. Remove the grinder parts from the sink and hand-dry them with a clean, old towel. There will still be rust on the metal that will stain the towel. Use something you don’t mind ruining to dry the pieces.

  4. Scrub the surface of the metal with a wire brush. If you have a wire attachment for your drill, it will work as well. Set the tool at a low speed to avoid scratching and damaging the surface. Run the wire from the brush or tool over each component until all remaining rust comes off.

  5. Clean the components with a mesh or steel wood pad under running water. Poke holes in the grinder disc with a stirrer or pipe cleanser to loosen embedded dirt and rust.

  6. Wash the components in soapy water and dry thoroughly with a clean towel.

  7. Apply a thin coat of spray-on oil to each piece before reassembling the grinder. This will protect the metal surfaces from future rusting.

The Drip Cap

  • Cast iron is malleable metal and part of a group known as ferrous alloys.
  • The best way to avoid rust on your cast-iron grinder is through proper cleaning.
  • Look for butterfly nuts or screws that will free the plate and release the components.
  • This will remove some of the surface rust.
  • Run the wire from the brush or tool over each component until all remaining rust comes off.
  • Clean the components with a mesh or steel wood pad under running water.