How to Use Used Tires for Cattle Waters

Save

If you raise cattle, no one needs to tell you how much water they drink on a daily basis, or how expensive it is to build a pond or purchase those huge prefabricated troughs to provide it for them. If you prefer to put your money into other things, consider building water troughs from used tires. Tires are virtually indestructible, and best of all, you can get them for free and save space in a landfill at the same time. Tires from a 150-ton dump truck are 8 feet across and hold about 450 gallons, according to Lilybrook Herefords.

Things You'll Need

  • Water source for trough, pre-installed
  • Concrete or compacted gravel pad, pre-installed
  • Truck or tractor tire, 6 to 13 feet in diameter
  • Reciprocating saws or heavy, sharp knife
  • Concrete pre-mix, approximately ½ yard or enough to fill center hole
  • Scrap metal fencing, cut to size of the tire's center hole
  • Prepare a concrete or compacted gravel pad slightly larger than the diameter of the tire you will be using, near the water source for your trough.

  • Use a reciprocating saw or a very sharp, heavy knife to remove the "bead" or sidewall on one side of the tire.

  • Position the tire, cut side up, on the prepared pad and center it.

  • Soak the pad thoroughly with water before mixing the concrete, so that it will not absorb any of the water from the concrete when poured and dry the mixture prematurely.

  • Mix concrete according to the directions on the bag.

  • Pour the concrete mix into the center hole of the tire where it sits on the pad and carefully work it under and around the opening to make good contact with both the pad and the underside of the tire around the bead. Fill about halfway to the rim of the bead.

  • Position the piece of scrap metal fencing--as concrete reinforcement--on top of the freshly poured concrete and continue filling the opening until it is flush or slightly above the bead.

  • Allow the concrete to firm up slightly, then fill the lower portion of the tire with water until a layer spills over the top of the poured concrete about ½ inch to 1 inch deep. This will protect the fresh concrete from drying out and allow a harder cure.

  • Keep the concrete wet for three to five days minimum. The longer it sets, the better and harder it will become when cured. Allow at least a week before using the trough to water livestock.

  • Fill the trough with water and allow it to overflow until the excess cement washes out of the trough; or pump out the water, rinse thoroughly, and refill.

Related Searches

References

  • Photo Credit 104 image by Sébastien Delaunay from Fotolia.com
Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!