How to Replace the Battery in a Palm Tungsten C

You don't need a new PDA, just a screwdriver.

The Palm Tungsten C is a PDA that comes with various features such as a color LCD screen and Internet access. It also comes with a built-in battery. Many Tungsten C owners usually just upgrade to a new PDA when the battery dies or becomes damaged, but you don't actually need to do this. If you have a few extra minutes you can open up the PDA and replace the battery on your own. You may learn a bit about electronics in the process.

Things You'll Need

• Phillips screwdriver (T5 size)

Instructions

1. Turn your Tungsten over and remove the screws from each of the four corners of the back of the device. Set the screws aside.

2. Pry the back panel gently off of the device and set it aside. The green motherboard will be visible in the front half of the unit.

3. Locate the battery cable on the top-left side of the motherboard and unplug it from the port.

4. Lift the motherboard up from its right side and turn it to the left like a page in a book to expose the back side of the board.

5. Pull the rectangular battery out of its compartment on the back of the board and set it aside. Flip the board back over and fit it back in the front housing.

6. Plug the battery cable in the port in the board and then replace the back cover and screws.

Tips & Warnings

• Opening your Tungsten C will void any warranty you may have on the unit.

References

• Direct Fix: Tungsten C Take Apart