How to Use Scalp Renew

Save

Nioxin Scalp Renew should be used once every 30 to 45 days to remove dead skin buildup and excess oil from your scalp. The product is easy to apply, as no heat is needed, and requires only 10 minutes to work. For best results, you may wish to have someone assist you with the application of Nioxin Scalp Renew to ensure complete coverage of the product.

Things You'll Need

  • Wide-tooth comb
  • Shower
  • Shampoo
  • Latex gloves
  • Timer

Comb your hair away from your face using the wide-tooth comb to release any loose skin or debris. Be sure to comb only in one direction.

Apply the product directly to your scalp, beginning at the front hairline. Squeeze the bottle to dispense the product and create lines from front to back, leaving approximately 1-inch gaps between the lines.

Apply lines of the product perpendicular to the front-to-back lines to create a grid. Again, ensure that a 1-inch gap is left between lines.

Outline your entire hairline with the product once the product has been applied both horizontally and vertically.

Work the product into the scalp with your hands until it is evenly distributed. Allow the product to sit for 10 minutes once distributed.

Rinse the product from your scalp with clean water. Continue rinsing until there is no more product visible in the water. Once clean, shampoo your hair to finish the Nioxin Scalp Renew application process.

Tips & Warnings

  • Always use hand protection when applying the product.
  • Do not allow product to make contact with your eyes.

Related Searches

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

This Is the Beauty Routine of an Ex-Pat in China

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!