There are many different types of thermostats, but they all work the same way. A bimetallic element (made by fusing two different metals together) inside responds to a change in temperature by bending as the metals expand at different rates when the element is heated or cooled. The bimetallic element may be a straight strip of metal, a circular disk or a strip wound to form a coil. As the element flexes, it opens or closes a set of electrical contacts, controlling the flow of current through the thermostat. Checking the operation of the electrical contacts is a straightforward task.
Things You'll Need
- Digital multimeter (DMM)
- Masking tape
- Needle-nose pliers
- Industrial hot air gun
Disconnect the wires from the thermostat to be tested. You will find two types of terminals used with thermostats, screw terminals or male-female push on terminals. In the case of screw terminals, loosen the screws with an appropriate screwdriver and remove the wires. In the case of male-female connectors, grasp the female push on-terminal with the needle nose pliers and pull them off. It does not matter which wire you connect to which terminal when replacing the wires on a two-wire thermostat, but if there are more than two wires, mark them with a small piece of masking tape on which you've written the terminal number, so you can reconnect them to the right terminals.
Set the "Function" switch on your DMM to the "Ohms" function. If your DMM is a manually ranging meter, set the "Range" switch to the lowest Ohms range. The lowest range on most manually ranging meters is a 200 Ohms. If your meter is an autoranging meter, it will select the appropriate range for you.
Clip one of the test leads from your DMM to each terminal on the thermostat. The meter will indicate an open circuit by displaying "OL" on its Liquid Crystal Display (LCD) for a good thermostat that has normally open (NO) contacts, or it will display zero (0.00) Ohms for a good thermostat that has normally closed (NC) contacts. You need to be aware that some DMM will read the resistance of their internal fuse, so you might get a reading of 0.5 Ohms instead of 0.00 Ohms for a good thermostat with closed contacts. A good thermostat with NC contacts should read zero resistance. A good thermostat with NO contacts should indicate infinite resistance, a reading of "OL" on the LCD. You should understand that if a thermostat passes this test, it may still be bad and need to be replaced.
Using the industrial hot air gun, apply heat to the thermostat. A thermostat with NC contacts should open eventually, and the reading on the LCD should swing from 0.00 Ohms to "OL" A thermostat with NO contacts should eventually close, and the LCD readout should swing from "OL" to 0.00 Ohms. If the thermostat does not respond in this way, it is bad and needs to be replaced.
- Photo Credit digital multimeter image by dinostock from Fotolia.com
How to Test Your Oven Thermostat
A faulty oven thermostat may result in a burnt entree or a pie or other baked dish that is cold in the...
How to Test an Electric Hot Water Heater Thermostat
There are few things more annoying than stepping into a cold shower because there is no hot water. The electric hot water...
How to Repair an Electric Dryer That Doesn't Heat
An electric dryer that runs but produces no heat has either a faulty thermostat or a faulty heating element. You will have...
How to Troubleshoot the Water Heater Electric Thermostats
The water temperature inside your water heater is controlled by one or two thermostats, depending on the size and the manufacturer. Once...
How to Check an AC Thermostat
If you think that your AC unit is malfunctioning, the culprit may actually be your thermostat. The thermostat tells the unit to...