Delta Bath Faucet Repair Instructions
Delta makes high-quality faucets, each with a wide range of features. The bath and tub faucets include scald protection and temperature controls. These faucets are not immune to repairs, however. Every now and again, your Delta faucet will require new parts to keep it running like new. As the seat washers wear out, you will discover leaks around the faucet head. Replace them, and these leaks will disappear. The fix takes only a few minutes. Does this Spark an idea?
Things You'll Need
- Allen wrench, 1/8 inch
- Screwdriver
- Needle-nose pliers
- Large pliers
- O-rings
- Seat washers
- New Delta faucet cartridge
Instructions
-
-
1
Turn off your home's water by closing the shut-off valves on the water pipe.
-
2
Remove the screw that attaches the faucet handle to the faucet stem. Use either a screwdriver (for Phillips-head screws) or an Allen wrench for Allen-head nuts. Lift the faucet handle off after the screw is removed. Save the screw for reuse.
-
-
3
Twist off the cap around the top of the faucet. This is a brass ring that is nearly flush with the head of the faucet. Use a pair of pliers to loosen and remove this part.
-
4
Place a cloth over the head of the faucet around the trim cap, the part located just above the base of the faucet. Grip the cap (around the cloth) with a pair of large pliers and twist it to the left to remove it. Pull this off the faucet. Remove the valve and the O-ring inside.
-
5
Lift out the seat washers with the tip of the Allen wrench. These are small, round rubber gaskets inside the two holes inside the faucet. Place new ones into the holes and make sure they are flush with the faucet bowl.
-
6
Replace the cartridge and O-ring next with brand-new parts designed for your faucet. Screw the nut back on. Replace the trim cap and tighten it by hand. Slide the handle onto the lever and replace the attaching screw with the Allen wrench.
-
1
References
Resources
- Photo Credit faucet image by Laura Dynan from Fotolia.com
