A faucet suspended in midair that appears to have running water flowing from its spout is a charming idea for a garden fountain. Your kids may think it's magic, but you can make a suspended-faucet fountain with a few supplies from the hardware store. Bury the fountain reservoir in the ground in your flowerbed to further enhance the illusion. You can also make a freestanding, suspended-faucet fountain with a bucket or decorative flowerpot as the reservoir.
Things You'll Need
- Decorative flowerpot, at least 10 inches in diameter
- 4 decorative metal feet
- Waterproof construction adhesive
- Submersible fountain pump
- Silicone sealant
- Rigid, clear-plastic tube, 24 inches long
- Rotary drill
- 1/8-inch drill bit
- Duct tape (optional)
- Wire mesh
- Wire cutters
Glue four decorative metal feet to the underside of a decorative flowerpot, using waterproof construction adhesive. Let the adhesive dry. The feet will elevate the flowerpot enough to feed the electrical cord through the drainage opening, making it less obtrusive.
Feed the power cord from the submersible pump through the flowerpot's drainage opening. Sit the pump in the center of the flowerpot. Close the opening around the cord with silicone sealant and let it harden.
Drill four 1/8-inch holes about a quarter-inch from one end of the 24-inch length of clear-plastic tubing. The holes should be opposite each other around the circumference of the tube--one each at the north, east, west and south points of the tubing. These holes will allow the water to flow out the side of the tubing as if it were falling from the spout.
Attach the end of the 24-inch, clear-plastic tube without holes to the spout on the submersible fountain pump. The tubing should fit over the fountain spout tightly; use duct tape to create a seal, if necessary.
Cut a length of wire mesh to fit inside the flower pot from the base to 2 inches below the rim, across the pot and down the other side to the base. Fold the mesh to form an inverted flat "U."
Slide the legs of the "U" against the sides of the flowerpot and feed the plastic tube through the center hole in the mesh. The flat portion of the "U" is the support for the decorative moss.
Turn the handle on the faucet spout to the off position. Attach the inside of the faucet spout to the end of the clear-plastic tubing with drilled holes, using silicone sealant or clear waterproof construction adhesive. Allow the adhesive to dry completely.
Fill the flowerpot with water, up to the wire mesh. Cover the mesh with decorative moss. Plug in the pump.
Tips & Warnings
- A 1/2-inch-diameter, clear-plastic tube will work in most cases, but if the faucet is large, select larger-diameter tubing. The tube needs to fit inside the faucet spout and over the fountain spout.
How to Make a Faucet & Bucket Fountain
Add interest to your landscaping with a charming country fountain you can easily make from a faucet and a bucket. You can...
How to Make the Handles on My Faucets Easier to Turn
A typical problem for many people, especially those with older homes, is faucet handles that are difficult to turn. When this happens,...
How to Convert a Faucet to a Drinking Fountain
Sometimes people just want a drink of water or want to rinse their mouths after brushing their teeth. In this case, a...
How to Make Your Own Faux Faucet Fountain
A faux faucet fountain can appear to have water running from a faucet spout that is suspended in air over a decorative...