How to Drill Four Holes in a Countertop for a Kitchen Faucet
Drilling the holes to mount a kitchen faucet onto a countertop is a relatively easy but important step. Wood laminate countertops can be bought in solid pieces, which enables the buyer to customize the sink and any other areas that will need to be cut out. In order to mount the faucet, you can use the rubber gasket or seal that comes with them as a template for the holes. Does this Spark an idea?
Instructions
-
-
1
Set the faucet on the countertop and determine the exact spot you want it to sit by the sink.
-
2
Remove the faucet and place the rubber gasket that has holes for the mounting bolts. This will be your template for the holes. Lay the gasket on the countertop where you want the faucet to be and center it using a tape measure.
-
-
3
Mark the mounting holes with a pencil and remove the rubber gasket. The holes for the water lines will also have to be marked, which will also be cut out of the gasket.
-
4
Drill the holes with a drill bit that is 1/16 inch larger than the mounting bolts. Use a hole saw drill bit to cut out the hole or holes for the water lines.
-
5
Place the faucet on the counter and bolt it down.
-
1
References
- Photo Credit faucet image by Mat Hayward from Fotolia.com
