A squeaking or squealing noise from your clothes dryer often means the rubber belt that turns the dryer drum has started hardening and losing its elasticity, causing it to slip as the drum turns. The belt will eventually have to be replaced, but you can extend its life with a much easier project: spraying the back of the belt with belt dressing, a sticky compound that's made to help mechanical belts grip better.
Things You'll Need
- Piece of chalk
- Spray can of belt dressing
Unplug the dryer. Open the door. Unscrew and remove the screws that are facing upward in the door opening, which will allow you to remove the top of the dryer. Reach inside the top and take out the screws that face forward, to remove the front. This will expose the dryer drum.
Trace the path of the rubber belt that encircles the drum and locate where it runs through the motor. It will generally be at the bottom, to one side. Find the point where the rubber belt rises off the drum on its way into the motor. Make a mark on the drum at that point with your piece of chalk.
Aim the can of belt dressing at the underside of the belt, where it's exposed as it rises off the drum by the motor. With your other hand, begin slowly turning the drum, while spraying the underside of the belt.
Continue turning the drum and spraying the belt until you see your chalk mark come around again, indicating that the entire belt has been sprayed.
Re-assemble the dryer in the reverse order of how you took it apart. Plug it in and run it to test for the squeak.