How to Remove Adhesive From Wood Furniture

Save

Glue is supposed to stick to things -- so if you get some on your wood furniture, you can't expect to simply wipe it off. Among the adhesives that can end up on your furniture, cyanoacrylate glue -- or super glue -- is probably the most difficult to remove. Polyvinyl acetate, or carpenter's glue, contact cement and construction adhesive are some other possibilities. It's highly doubtful you'll be able to get any of these adhesives off without some degree of damage to the finish. The key is to minimize that damage so you can make a clean repair.

How to Remove Adhesive From Wood Furniture
(Sarah Vantassel/Demand Media)

Things You'll Need

  • Pull scraper
  • Razor knife
  • 320-grit sandpaper
  • Furniture polish
  • Clear finish
  • Rag
  • Mineral spirits
  • Olive oil
  • Acetone
  • Cotton swab
Step 1

Scrape off dried carpenter's glue, construction adhesive and ceramic tile mastic with a pull scraper or a razor knife. A pull scraper gives you more control than a razor knife and is best for large glue deposits, especially if it has a sharp blade. A razor knife is better suited for removing small dabs of dried PVA glue. Just force the blade under the glue spots -- they usually pop off.

Sarah Vantassel/Demand Media
Step 2

Draw the pull scraper carefully over the surface of the glue deposit, removing just the top layer. Continue removing the glue in layers until the scraper contacts the finish. You may have to scrape off a layer of finish to completely remove the glue. Work carefully to avoid scraping all the way through to the wood.

Sarah Vantassel/Demand Media
Step 3

Sand the area with 320-grit sandpaper after you've removed all the glue. Surface damage to the finish may not be noticeable after you apply a coat of furniture polish; if it seems like you can't mask the damage with polish, apply a fresh coat of finish before you apply polish. Spray new lacquer or polyurethane varnish from an aerosol can. Sand it when it dries, and spray a second coat.

Sarah Vantassel/Demand Media
Step 1

Rub dried construction adhesive, ceramic tile mastic and contact cement with a rag moistened with mineral spirits. This weak solvent won't harm the finish and may soften the adhesive enough for you to roll it off with your fingers, but this may take several minutes.

Sarah Vantassel/Demand Media
Step 2

Make a 1-to-1 mixture of mineral spirits and olive oil, and apply the mixture liberally to the glue if you can't soften it by rubbing with mineral spirits. Cover the glue spot with a rag and leave it for several hours. Pull or roll it off with your fingers when it softens.

Sarah Vantassel/Demand Media
Step 3

Remove cyanoacrylate glue with acetone. This is a strong solvent, also used as nail polish remover, that will damage most finishes so apply it sparingly. Dab it onto the glue with a cotton swab and rub off the glue when it softens. Sand the finish when it hardens; touch up with two coats of clear coat.

Sarah Vantassel/Demand Media

Related Searches

Tips & Warnings

  • If you don't know what kind of finish is on the affected furniture, you can test it with a simple procedure. Dab an inconspicuous area with a cotton swab moistened with lacquer thinner. If the finish softens, it's lacquer. If it doesn't, it's varnish.
  • If you decide to scrape the glue off, don't soften it first with a solvent. It's easier to scrape when it's hard.

References

Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!