How to Install an Aluminum Fascia

Save

Aluminum fascia covers the rafters' end board that runs around the perimeter of the roof. The fascia is cut to cover the front of the end board, from top to bottom. The bottom edge of the aluminum fascia wraps under the end board and up to the bottom of the soffit. Aluminum fascia comes precolored from the factory and does not require regular painting to maintain its appearance, thus allowing it to provide years of low-maintenance service.

Things You'll Need

  • Aluminum or stainless-steel nails
  • Hammer
  • Tin snips
  • Lay out the aluminum fascia, starting at one corner of the rafters' end board. Go clockwise or counterclockwise until you get back to your starting point. Allow a 1-inch overlap where pieces meet.

  • Lay the first piece of fascia in place on the end board. Attach it to the end board by hammering in aluminum or stainless-steel nails. Space the nails 24 to 36 inches apart.

  • Lay the next piece of fascia in place, overlapping the first piece by 1 inch. Nail the fascia into place as before. Continue laying and nailing fascia pieces in the same way, until you get to a corner.

  • Hold the fascia in place at the corner. Scribe the location of the corner onto the aluminum with the point of a nail. Cut a dart -- an inverted "V" -- in the bottom flange of the fascia with a pair of tin snips.

  • Scribe a line vertically from the top of the dart to the top of the fascia on the back side to form a crease. Fold the fascia until the desired angle to go around the corner is achieved.

  • Lay the fascia section in position over the corner. Nail it in place. Continue installing fascia pieces around the house until the entire end board is covered.

Tips & Warnings

  • Use caution when cutting and handling the fascia. The cut edge may be very sharp and has the potential to cause serious injury.
  • Take your time and be careful when nailing up the pieces. The aluminum is rather soft and hammer marks remain visible if you miss the nail and hit the fascia.

Related Searches

References

  • Photo Credit Hemera Technologies/AbleStock.com/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Fasten Aluminum Fascia to the Top of the Gable

    Freshly painted fascia board is attractive. Within a couple of years, however, the paint can start to peel and you’re looking at...

  • How to Bend Aluminum Fascia

    How to Bend Aluminum Fascia. When installed correctly, aluminum fascia can protect the underside and hard-to-reach areas of your home from water...

  • How to Install Fascia

    The fascia on a home is the board that is nailed across the edge of the roof behind the gutters. If you...

  • DIY: How to Install Metal Fascia Eaves

    Metal fascia is not only visually appealing, it prevents moisture from getting into your faceboard, rakeboards, rafters and roof eaves. It also...

  • How to Install a Vinyl Fascia Cover

    Installation of vinyl siding to a building may be just the ticket for a maintenance-free, yet visually pleasing exterior surface. But the...

  • How to Nail Aluminum Fascia

    A siding job won't look complete without all of the trim-work. Fascia is the trim that surrounds the soffit panels on the...

  • How to Wrap Fascia

    Wooden fascia boards are commonly used to trim around the eaves of homes, running in 1x8 or 1x6 pieces all the way...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!