The garage door safety sensors are the primary safety mechanisms on your garage door. They pass an invisible beam between each other. When the beam is broken as the door is traveling down, the opener will stop the door and reverse back to the open position. Most closing issues are a result of misaligned safety sensors. Align the safety sensors on your garage door and you will have the opener working properly. The key to aligning the sensors is determining which sensor is the receiving one.
Things You'll Need
- 7/16-inch wrench
Grasp the mounting bracket with the claw of a hammer, if the sensor bracket is bent. Straighten the bracket to allow the sensor to face the opposite sensor.
Find the LED light on each of the safety sensors, and look for the one whose LED light is flickering or will not illuminate. Place a ball in between the path of the safety sensors. Look for the sensor whose LED light stops illuminating. This is the receiving sensor, and the one that requires adjusting. Move the ball out of the way.
Loosen, but do not remove, the securing nut on the back of the sensor with a 7/16-inch wrench.
Maneuver the sensor up and down until the LED illuminates without flickering. Hold the sensor steady and tighten the securing nut. Continue adjusting as necessary until the LED light remains lit when the sensor is secure.
How to Align Garage Door Sensors
If your garage door sensors are not working properly, they may be either dirty or out of alignment. To be sure they...
How to Bypass a Garage Door Sensor
The garage door is the single largest moving object in your home. Because of this, garage door openers have several safety mechanisms...