Paneled doors provide architectural interest and detail. Most paneled doors will last for decades without need of major repairs. A well-maintained door will weather changes in humidity and temperature; however, severe changes and rough weather can damage the finish and cause the joints in the frame holding the panels to shrink or swell and eventually separate. Repairs can be made with common tools in a short amount of time, saving you hundreds of dollars in door-replacement costs.
Things You'll Need
- Razor scraper
- Wood chisel
- Rubber mallet
- Wood glue
- Bar clamps
Remove the door from its hinges by tapping a screwdriver up through the bottom of the hinge to drive the pin out of the hinge. Lay the door on a pair of sawhorses to make the bottom panel easily accessible.
Scrape any old glue from the joints on either side of the bottom door rail with a razor scraper or sharp wood chisel. The rail is the bottom horizontal piece and is typically joined to the two outside vertical pieces, known as stiles. Scrape any old glue from the joint along the top of the rail as well.
Tap along the bottom of the door with a rubber mallet or hammer and woodblock to move the rail up into its original position with the bottom of the rail flush with the ends of the two side stiles. Tap the stiles in toward the center of the door to their original position to check the fit.
Tap a chisel or small flat pry bar into the joints at either side of the bottom rail and pry out slightly to access the tenon, or tongue, at each side of the rail. Apply wood glue to both faces of this tongue on either side of the rail. Tap the rails back into position.
Apply two bar clamps the width of the door, pressing against the outside edges of the stiles. Use folded cardboard or wood shims to pad the clamps where they touch the door. Tighten the clamps to hold the stiles firmly against the sides of the rail. Leave the clamps in place for at least three to four hours, overnight if possible, to allow the glue to harden.
Remove the clamps and hang the door back on its hinges. Apply a coat of polyurethane to the seams along both sides of the rail to seal it and prevent future problems.
- "Doors and Windows": Various Authors; Taunton Press, 2006
- Popular Mechanics: Eight Common Clamps
- Photo Credit door usury image by Madera from Fotolia.com
How to Fix a Wood-Burning Stove
Promptly fixing any problems with your wood-burning stove is essential for your personal safety. It also maximizes energy efficiency and minimizes air...
How to Replace an Exterior Door Threshold
The door threshold plays a critical role in keeping your home airtight. A properly installed threshold helps to keep pests out, but...
How to Caulk Exterior Wood Siding
Wood siding is a complex series of boards that overlap in a certain way to channel water to the base of the...
How to Replace the Panel on an Exterior Wood Door
Some exterior wood doors are made from panels fitted into a frame. These are called panel doors and come in both raised-...
How do I Repair a Crooked Exterior Door?
Crooked doors wobble, stick and rub. And the longer a crooked door is left unfixed, the worse the problem gets. If it's...
How to Fix a Broken Door Frame
The door frame holds the door level. It also houses the locks that keep you and your family safe. The door jamb...