The ignition coil on a Harley Davidson motorcycle is an essential component of the ignition system. It consists generally of two sets of wires that are wrapped around an iron core. This component comes sealed, and is not a repairable item. Fortunately, testing is relatively straight forward, requiring a pair of resistance measurements made at the connection terminals on the coil. The time necessary to complete this task should be no more than 15 to 20 minutes.
Things You'll Need
- SAE wrench set
Turn off the motorcycle. Allow the engine to become cool to the touch before proceeding.
Disconnect, by hand, the two spark plug wires from the coil. Unscrew the smaller connections on the coil with an SAE wrench.
Set the ohmmeter to read resistance on the "Rx1" setting. Measure the resistance across the two smaller terminals on the coil. The meter should read between 2.5 and 3.1 ohms.
Set the ohmmeter to read resistance on the "Rx1000" setting. Measure the resistance across the two larger terminals on the coil. The ohmmeter should read between 10,000 and 12,500 ohms.
If the meter reads outside of the ranges for either of the above measurements, then the coil is faulty and should be replaced.
Tips & Warnings
- Sometimes a coil will only give a faulty reading when it is hot from riding. In this instance, it may be necessary to allow the coil to heat up before performing a resistance measurement. Exercise extreme caution when working around a hot motorcycle.
- "Service Manual for Softail Models;" Harley-Davidson; 2000
- Online Repair Course
- Photo Credit motorcycle image by Greg Pickens from Fotolia.com
How to Test a Single Fire Coil
The single fire ignition coil is a critical component of any internal combustion engine's electrical system. The coil is a simple electrical...
How to Check the Resistance of a Motorcycle Ignition Coil
Motorcycle engines rely on three different ingredients to create combustion: air, fuel and spark. If any of these factors are missing, combustion...
How to Wire a Stock Harley Ignition to an SE Coil
Harley-Davidson ignition coils provide stepped-up voltage to the spark plugs. The ignition module reads engine RPM (revolutions per minute) and crankshaft position,...
How to Test Ignition Coils
From coils and coil packs to electronic ignitions and computers, the ignition system can be a mystery. How do you know whether...
How to Check a Motorcycle Ignition Coil
The ignition coil on a motorcycle serves to step up the relatively low battery voltage to the high voltage needed to fire...
How to Install an Ignition Switch on a Harley
Some Harley owners repair their own bikes. This saves a service bill and time off riding. When an ignition switch is bad,...
How to Test a Faulty Ignition Coil Wire
Many electrical issues can be traced to loose or damaged wiring. Often however, the problem cannot be located through visual inspection, as...
How to Test a 12 Volt Delco Coil
Gasoline-powered vehicles manufactured by General Motors up until the late 1990s rely upon an ignition coil. Consisting of primary and secondary coils,...
Motorcycle Ignition Problems
Motorcycle ignition systems are exposed to very harsh operating conditions. Many components are exposed to the elements. High engine temperatures effect the...