Fiberglass is a manmade product, in use since the 1930s for filtration and insulation. In modern times, shower stalls, bathtubs, kayaks, boat hulls and many other objects contain fiberglass. When you saw, trim, or handle fiberglass, small fibers work their way into the skin of your hands and arms, creating an irritating itch.
Things You'll Need
- Natural soap
- 1/2 cup baking soda
Disrobe carefully, taking care not to drag your shirt over your arms or hands. Pressure on the skin can drive the fiberglass splinters deeper into your skin, making removal much more difficult.
Enter your shower and turn on the hot water and a small amount of cold water. Stand away from the water stream for several minutes. The goal is to work up steam in the enclosed space without getting your hands or arms wet. The steam opens your pores and increases the chances of the splinters falling out.
Adjust the water to a comfortable temperature and step back into the stream. Allow the water to run off of your arms and hands. If any of the splinters were loosened as a result of the steam, this step will rinse them away.
Add natural soap to a non-coarse loofah and gently brush the skin on your hands and arms. Do not apply pressure, as doing so will drive any remaining splinters deeper. Rinse your hands and arms with water to remove the soap.
Turn off the water and dry your hands and arms by lightly pressing the towel against the skin. Do not drag the towel.
Put on a loose-fitting, sleeveless shirt. If you are still experiencing irritation, move on to the next section.
Baking Soda Paste
Add 1/2 cup of baking soda to a bowl.
Add a small amount of water. Mix the baking soda and water into a paste with your fingers. If the paste is too dry and powdery, add more water. If the paste is too soupy, add more baking soda.
Dress any itchy areas on your hands or arms with the paste.
Allow the paste to dry for 25 to 30 minutes. Try not to move your hands or twist your wrist while the paste dries. The powder will harden around the exposed sections of the fiberglass splinters.
Rinse the dried baking soda off of your skin. Any fiberglass splinters that became attached to the paste will pull out and rinse away.
Tips & Warnings
- Remove your clothing and hose off your arms and hands immediately after working with fiberglass to avoid irritation in the future.
- Powder your skin before working with fiberglass. The powder may block fibers from entering your skin.
- If you have fiberglass on your hands, do not touch your nose, mouth, ears or eyes.
- Photo Credit Just an Arm image by Radio from Fotolia.com
How to Remove Fiberglass From Skin
Fiberglass is a tricky substance to get rid of, especially after it has embedded itself deep into the pores of your skin....
How to Remove Fiberglass From Hands and Fingers
Fiberglass is a material often used by builders and construction workers for insulation. Fiberglass contains small, sharp splinters of glass that are...
How to Remove an Arm Cast
An orthopedic cast on a patient's arm, despite limiting his lifestyle, will help a broken bone heal much faster than without one....
How to Remove a Fiberglass Cast
Modern-day casts are made from one of two kinds of material: fiberglass or plaster. Fiberglass casts are lighter and come in a...