Homemade 75 Ohm FM Antenna

Techwalla may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

If you have an FM receiver with a jack for an external antenna, you'll note that the jack is usually specified for 75-ohm antennas. If you're unfamiliar with an antenna design, building an antenna that will work at a specific resistance may seem like a difficult task. But it actually isn't--you can build an antenna that works with a 75-ohm input fairly easily and inexpensively.

Advertisement

Step 1

Cut a 30-inch length of 300-ohm twin lead cable. Don't be concerned that the cable is a 300-ohm cable and you're making a 75-ohm cable. The cable is merely used as the active element that receives the signal.

Video of the Day

Step 2

Remove 1/2 inch of insulation from the both ends of the cable. Twist together the separate leads at each end of the cable.

Advertisement

Step 3

In the middle of the cable, cut one of the two elements of the cable and remove 1/2 inch of insulation from either side of the cut with your wire strippers.

Step 4

Solder each bare wire from the middle cut to one of the tabs of a 300- to 75-ohm transformer.

Advertisement

Advertisement

Step 5

Connect one end of the coaxial cable to the transformer by plugging it in.

Step 6

Connect the other end of the coaxial cable to the antenna input of your receiver.

Video of the Day

Advertisement

Advertisement

Report an Issue

screenshot of the current page

Screenshot loading...