How to Troubleshoot an Iomega Zip 250 External USB
The Iomega Zip 250 external USB is an Zip drive that functions just like a standard floppy disk drive, only instead of backing up 1.44 megabytes of information, it can hold 250 megabytes of data. However, while using the disk drive with any computer you can run into a few issues, typically resulting in the inability to save data to the drive. These issues can be fixed with a few troubleshooting steps.
Other People Are Reading
Instructions
-
-
1
Check the USB cable connection running from the Iomega Zip drive to the computer. Make sure the USB data cable is inserted securely into both USB ports. If one side is not inserted completely, the data transfer will not to reach the Zip drive.
-
2
Insert a new Zip disk. If the previous Zip disk is full, you cannot save additional files or programs to the device. If you only have one Zip disk, right-click a file you no longer use and select "Delete" to clear room on the disk.
-
-
3
Install the Iomega Zip 250 drivers onto the computer. Without the installed drivers you cannot use the device on the system (unlike other standard USB devices, the computer does not know how to save to the exterior disk without installed drivers).
-
4
Press and hold down on the "Eject" button if the Zip disk will not eject out of the Iomega device. Holding down the "Eject" button often corrects the issue. However, if that does not correct the problem, shut down the drive (press the power switch on the back of the drive), leave it off for a few moments, then power it back on. You can now eject the Zip 250 drive.
-
5
Check the front of the Zip disk. Although you can use disks that store up to 250 megabytes, it is possible to use a Zip 100 (100 megabytes) with the drive. If the disk is not storing the 250 megabytes worth of data, it may be due to the disk not being able to store that much data.
-
1
References
- Photo Credit old zip drive image by Wayne Abraham from Fotolia.com
